User Manual for Aigostar LED Sensor Cabinet Light
Quick guide for the Aigostar LED sensor cabinet light. Includes installation instructions, gesture control operation, technical specifications, and safety guidelines.
Table of contents
Quick guide from the manual
This manual provides instructions for the Aigostar LED sensor cabinet light (models HLLEDCL-3W and HLLEDCL-6W). The device is intended for indoor use, such as in homes, offices, or hallways, and features gesture-based control.
Installation
The light can be installed using one of two methods:
- 3M Adhesive Tape: Peel and stick the adhesive backing to the desired clean, flat surface.
- Screw Installation: Use the provided screws to mount the light securely to the surface.
Operation
The light is operated via gesture sensing:
- Turning On/Off: Move your hand within 200mm of the sensor to toggle the light.
Maintenance and Safety
To ensure safe operation and longevity:
- Use a USB adapter with an output of 5V/0.7A (for 3W model) or 5V/1.5A (for 6W model).
- Clean the device regularly with a soft, dry cloth. Do not use abrasive cleaners.
- Do not modify the product or attempt to replace the light source.
- For indoor use only.
Technical Specifications
- Input Voltage: 5V
- Power: 3W (HLLEDCL-3W) or 6W (HLLEDCL-6W)
- Sensing Distance: <200mm
- Waterproof Level: IP20
Manufacturer information
Aigostar
Practical help
Common problems
Check if the USB adapter provides the correct voltage (5V) and sufficient current (0.7A for 3W, 1.5A for 6W).
Ensure the gesture is performed within 200mm of the sensor.
Before use
- Verify the USB adapter output matches the model requirements (5V/0.7A or 5V/1.5A).
- Clean the mounting surface thoroughly before applying 3M adhesive tape.
- Ensure the installation location is indoors and dry.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.