Cell2 6LED Single Colour Lighthead 150629M60

Product Overview

The Cell2 6LED Single Colour Lighthead is a compact, surface-mounted warning light designed for high visibility. It features multiple flash patterns and synchronization capabilities, making it suitable for various vehicle safety applications.

Installation and Wiring

Proper installation is critical for safe operation. Ensure the unit is mounted securely to the vehicle chassis. The wiring configuration is as follows:

• RED: Connect to +VDC (must be fused at 3A).
• BLACK: Connect to Chassis Ground.
• YELLOW: Used for synchronization and flash pattern selection.

Synchronization and Grouping

To synchronize multiple lightheads, connect the YELLOW wires of all units together. All connected heads must be set to the same flash pattern.

For simultaneous or alternating flash effects, use the Grouping mode:

• Enter Grouping mode by applying +VDC to both RED and YELLOW wires simultaneously. The lighthead will indicate its current group with short flashes: a single flash represents Group 1, and a double flash represents Group 2.
• To change groups, remove the YELLOW wire from +VDC and momentarily apply it to +VDC again.
• Heads within the same group will flash together, while Group 1 heads will alternate with Group 2 heads.

Flash Pattern Selection

The lighthead offers 16 distinct flash patterns. To change the pattern, momentarily apply +VDC to the YELLOW wire:

• Apply once to advance to the next pattern.
• Apply quickly three times to reset the device to Flash Pattern #1.

Available patterns include various frequencies of Double, Single, Triple, Quad, Quint, Ultra, and Mega flashes, as well as Steady burn and complex combinations like Single-Quad, Single H/L, and Single-Triple-Quint.