User Manual for Danfoss EKA 181C Battery Module

Quick guide for the Danfoss EKA 181C battery module. Learn how to safely install the module into compatible controllers like EKC 202, AK-CC 210, and AK-CC 250.

Table of contents

Quick guide from the manual

The EKA 181C is a battery module designed for specific Danfoss controllers. Installation is straightforward but requires the device to be powered off to prevent electrical issues or damage to the module.

Installation

Ensure the controller is powered off.
Insert the EKA 181C battery module into the designated slot on the controller.
Power on the controller.

Compatibility

This module is compatible with the following Danfoss controllers:

EKC 202
AK-CC 210
AK-CC 250

Manufacturer information

Danfoss A/S

Brand profile

Manufacturer website https://www.danfoss.com Support https://www.danfoss.com/en/service-and-support/ Manufacturer manuals https://www.danfoss.com/en/service-and-support/downloads/

Practical help

Common problems

Module not recognized

Ensure the controller was powered off during installation and that the module is fully seated in the slot.

Before use

Ensure the controller is powered off
Verify compatibility with EKC 202, AK-CC 210, or AK-CC 250
Handle the module carefully

Manual page author

Emily Carter

User documentation editor

Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.