Enerlites 61150 15A Single Receptacle Installation Instructions
Installation guide for the Enerlites 61150 15A single receptacle. Includes wiring diagrams, safety warnings, wire gauge requirements, and torque specifications for proper electrical installation.
Table of contents
Important Safety Information
WARNING: Risk of electric shock or death. Always disconnect power at the circuit breaker or fuse box before beginning any electrical installation. This product must be installed by a qualified person in accordance with national and local electrical codes.
Installation Requirements
- Conductor Type: Use copper conductors only.
- Wire Gauge: Compatible with 12AWG to 14AWG wire.
- Insulation Removal: Strip 5/8 inch (15.9mm) of insulation from the conductors.
- Torque Specifications: Tighten terminal screws to 9-12 pound-inch (1.0-1.4 Nm).
Wiring Diagram
The receptacle features three main connection points:
- Hot (Black wire): Connect to the brass/yellow screw.
- Neutral (White wire): Connect to the silver/white screw.
- Ground (Green or bare wire): Connect to the green screw.
Ensure the conductor is wrapped securely around the terminal screw before tightening.
Practical help
Common problems
Ensure power is disconnected at the circuit breaker before starting installation.
Wrap the conductor securely around the terminal screw and tighten to 9-12 lb-in (1.0-1.4 Nm) of torque.
Before use
- Verify power is turned off at the source
- Confirm use of copper wire only
- Ensure wire gauge is between 12AWG and 14AWG
- Strip 5/8 inch of insulation from the wire ends
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.