Installation Guide for Enerlites 66215/66205 Flanged Inlet
Quick installation guide for the Enerlites 66215 and 66205 15/20 Amp 125VAC Flanged Inlet. Includes hole dimensions, required tools, and step-by-step mounting instructions.
Table of contents
Quick installation guide
This document provides the necessary steps to install the Enerlites 66215 and 66205 15/20 Amp 125VAC Flanged Inlet. Ensure you have the correct tools before beginning the installation process.
Tools required
- Power drill
- 1-3/4 inch hole saw
- #2 screwdriver
Installation steps
- Use the provided template to drill a 1-3/4 inch diameter hole in the mounting surface.
- Feed the cord through the cutout until the flanged inlet is flush with the installation surface.
- Use a 1/8 inch drill bit to pre-drill the mounting holes for the screws on hard surfaces.
- Secure the flanged inlet to the surface using the provided screws.
- Plug in a live cord. The unit is now ready to use or cover when not in use.
Hole dimensions
The installation requires a hole with a diameter of 1-3/4 inches. Ensure the surface is prepared correctly before drilling.
Practical help
Before use
- Ensure you have a power drill
- Obtain a 1-3/4 inch hole saw
- Verify the installation surface is suitable for mounting
- Check that you have a #2 screwdriver
Model compatibility
- Compatible with 15A and 20A circuits.
- Designed for 125VAC electrical systems.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.