Frigidaire 11NBRRFLSS Range Rear Filler Installation Guide
A concise installation guide for the Frigidaire 11NBRRFLSS range rear filler, including step-by-step instructions for mounting the component to ensure a proper fit.
Table of contents
Quick guide from the manual
This document provides instructions for installing the rear filler component on Frigidaire front control freestanding ranges. The installation process involves removing existing screws from the back of the range, positioning the filler, and re-securing it.
Safety information
Before beginning the installation, you must disconnect the electrical power to the range. Ensure the appliance is turned off and all surfaces are completely cool to the touch to prevent burns or other injuries during the installation process.
Installation procedure
- Remove existing screws: Locate the three screws across the top rear of the range. Remove them and keep them in a safe place, as they will be reused.
- Position the filler: Align the tabs located on the rear filler component with the corresponding holes on the back of the range.
- Secure the filler: First, replace the center screw to hold the filler in place. Align and level the filler piece, then insert and tighten the remaining two screws to secure the component firmly to the range.
Manufacturer information
Frigidaire
Practical help
Common problems
Ensure the center screw is installed first to act as a pivot point, then level the filler before tightening the two outer screws.
Before use
- Disconnect electrical power to the range
- Ensure the range is turned off
- Verify that all surfaces are cool to the touch
- Ensure you have the 3 original screws removed from the range
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.