User Manual for Globo Lighting 21037G Table Lamp
Quick guide for the Globo Lighting 21037 series table lamp. Learn how to charge the battery, operate the touch controls, adjust brightness, and change light color temperatures.
Quick answers from the manual
Quick answer
- The Globo Lighting 21037 series lamp is operated via a touch sensor. Short press to turn on/off or change color temperature (2700K, 4500K, 6000K). Long press to adjust brightness. p. 1
Key actions
- Charge the lamp using the included USB-C cable and a 5V charger. p. 1
- Adjust brightness by long-pressing the touch sensor. p. 1
First start
- Charge the device for 4-6 hours before initial use. p. 1
Show 2 more answers Show less
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Power | 1.2W | Maximum LED power | p. 1 |
| Battery | 3.7V 1200mAh | Rechargeable Li-ion battery | p. 1 |
Where to find it in the PDF
- Operation and Charging Guide p. 1
- Light Source Disclaimer p. 2
Table of contents
Quick guide from the manual
This document provides instructions for the Globo Lighting 21037 series table lamps (21037G, 21037C, 21037S, 21037CS). The lamp is operated via a touch sensor and is powered by a rechargeable battery.
Charging the lamp
The lamp uses a built-in 3.7V 1200mAh Li-ion battery. To charge:
- Connect the included USB-C cable to the lamp.
- Connect the other end to a 5V USB charger (not included).
- Charging takes approximately 4-6 hours.
Operation
The lamp is controlled using the touch sensor on the base:
- On/Off: Short press the touch sensor.
- Brightness adjustment: Long press the touch sensor to continuously dim or brighten the light.
- Color temperature: Short press the touch sensor to cycle through light modes: 2700K, 6000K, and 4500K.
Light source
The LED light source is integrated into the product design and cannot be replaced.
Manufacturer information
Globo Lighting
Practical help
Common problems
Ensure the battery is charged. Connect the USB-C cable to a 5V power source for 4-6 hours.
Verify that the USB charger used provides 5V output and that the cable is securely connected.
Before use
- Charge the battery fully (4-6 hours) before first use.
- Ensure you have a 5V USB charger available (not included).
- Check that the touch sensor area is clean.
Manual page author
David Miller
Documentation analyst