Installation Guide for Globo 2001703C Wall Lamp
Step-by-step installation guide for the Globo 2001703C wall lamp. Includes wiring instructions, bulb requirements, and technical specifications for safe mounting.
Quick answers from the manual
Quick answer
- The Globo 2001703C is a wall lamp requiring two E27 bulbs (max 60W each). Installation involves mounting the base, connecting the wiring, attaching the body, and installing the bulbs. p. 1
Key actions
- Installation p. 1
First start
- Turn off power at the circuit breaker, mount the base, connect wires, attach body, install bulbs, and turn power back on. p. 1
Show 2 more answers Show less
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Bulb Type | 2 x E27 | Requires two E27 bulbs | p. 1 |
| Voltage | 230V~ 50Hz | Standard mains voltage | p. 1 |
Where to find it in the PDF
- Installation Diagram p. 1
Table of contents
Important Safety Information
Before beginning the installation, ensure that the power supply is turned off at the main circuit breaker. Electrical work should be performed with caution to avoid electric shock.
Installation Steps
- Power Off: Switch off the power at the circuit breaker before starting any work.
- Mounting: Secure the base of the lamp to the wall using the provided screws.
- Wiring: Connect the electrical wires to the terminal block, ensuring correct connection of Neutral (N), Live (L), and the Ground wire.
- Assembly: Attach the main body of the lamp to the wall base and secure it with the screws.
- Bulb Installation: Insert two E27 bulbs into the sockets.
- Finishing: Attach the covers/diffusers to the lamp body.
- Power On: Switch the power back on at the circuit breaker.
Technical Specifications
- Bulb Type: 2 x max 60W E27
- Voltage: 230V~ 50Hz
- Protection Rating: IP44 (Splash-proof, suitable for damp areas)
Manufacturer information
Globo Lighting
Practical help
Common problems
Light does not turn on
Check if the bulbs are properly screwed in and the circuit breaker is switched on.
Before use
- Ensure power is turned off at the main breaker
- Verify wall surface is suitable for mounting
- Check that you have two E27 bulbs (max 60W each)
Manual page author
David Miller
Documentation analyst