findmanualpdf.com

Installation Guide for Hilti S-MD 01Z 6.3x19 Fastener

Quick installation guide for the Hilti S-MD 01Z 6.3x19 fastener. Includes technical specifications, compatible tools, drilling capacity, and correct installation procedures to ensure proper fastening.

Table of contents

Quick guide from the manual

This document provides essential installation parameters for the Hilti S-MD 01Z 6.3x19 fastener. Ensure you use the correct tool speed and socket to prevent damage to the fastener or the base material.

Technical specifications

  • Fastener Diameter: 6.3 mm
  • Head Size: 10 mm
  • Maximum Material Thickness (MFmax): 7 mm
  • Drilling Capacity (DC): 1.2 - 3 mm
  • Material Finish: Zinc plated

Installation procedure

  1. Tool Setup: Ensure your installation tool (ST 1800, ST 1800-A, or SF (H)) is set to a speed between 1200 and 2000 1/min.
  2. Socket Selection: Use the S-NS 10 socket for installation.
  3. Driving: Apply consistent pressure while driving the fastener.
  4. Alignment: Keep the tool perpendicular to the surface. Do not tilt the tool during installation.
  5. Final Check: The fastener head must be flush with the surface. Ensure there is no gap between the fastener and the material, and that the material is not damaged.

Important warnings

  • Do not use impact drivers: Using an impact driver is prohibited and may damage the fastener.
  • Avoid overtightening: Stop driving immediately once the fastener is flush with the surface to prevent stripping or damage.

Manufacturer information

Hilti Corporation

Brand profile
Manufacturer website https://www.hilti.com Support https://www.hilti.com/content/hilti/global/en/support.html Manufacturer manuals https://www.hilti.com/content/hilti/global/en/technical-literature.html

Practical help

Common problems

Fastener not seating correctly

Ensure the tool is held perfectly straight and not tilted during the driving process.

Fastener overtightened or damaged

Stop driving immediately when the fastener head is flush with the surface. Do not use impact drivers.

Tool incompatibility

Use only recommended tools: ST 1800, ST 1800-A, or SF (H).

Before use

  • Verify the base material thickness is within the 1.2-3mm drilling capacity range.
  • Set the tool speed to 1200-2000 1/min.
  • Ensure you are using the S-NS 10 socket.
  • Confirm the fastener is suitable for the environment (Zinc plated).

Manual page author

Emily Carter

User documentation editor

Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.