findmanualpdf.com

Hilti S-MD 01Z 6.3x19 Fastener Installation Guide

Installation guide for Hilti S-MD 01Z 6.3x19 fasteners. Includes technical specifications, drilling capacity, compatible tools, and correct installation procedures.

Table of contents

Manual images

Click an image to enlarge
Technical specifications and dimensions for the S-MD 01Z fastener. Page 1 Step-by-step installation instructions. Page 1

Quick guide for Hilti S-MD 01Z 6.3x19 installation

This guide provides essential information for the correct installation of Hilti S-MD 01Z 6.3x19 fasteners. Ensure you use the correct tool speed (1200-2000 rpm) and the S-NS 10 socket to prevent damage to the fastener or the material. Always maintain a straight angle during installation and avoid overtightening to protect the seal.

Technical specifications

Technical specifications and dimensions for the S-MD 01Z fastener.
Technical specifications and dimensions for the S-MD 01Z fastener.
  • Model: S-MD 01Z 6.3x19 (#219559)
  • Drilling Capacity (DC): 1.2mm to 3mm
  • Max Material Thickness (MFmax): 7mm
  • Head Size: 10mm
  • Material Finish: Zinc plated

Installation procedure

Step-by-step installation instructions.
Step-by-step installation instructions.
  1. Tool Setup: Use a compatible tool such as ST 1800, ST 1800-A, or SF (H). Set the tool speed between 1200 and 2000 rpm.
  2. Socket Selection: Use the S-NS 10 socket for driving the fastener.
  3. Positioning: Place the fastener perpendicular to the surface. Do not tilt the tool during the drilling process.
  4. Driving: Apply steady pressure and drive the fastener until it is seated correctly.
  5. Completion: Stop immediately once the fastener is seated. Do not overtighten, as this will damage the seal and the fastener head.

Manufacturer information

Hilti Corporation

Brand profile
Manufacturer website https://www.hilti.com Support https://www.hilti.com/content/hilti/global/en/support.html Manufacturer manuals https://www.hilti.com/content/hilti/global/en/technical-literature.html

Practical help

Common problems

Overtightening

Stop driving immediately once the fastener is seated to avoid crushing the seal.

Incorrect tool speed

Ensure the tool is set between 1200 and 2000 rpm.

Tilting the tool

Keep the tool perpendicular to the surface during the entire installation process.

Before use

  • Verify material thickness is between 1.2mm and 3mm.
  • Ensure the tool speed is set to 1200-2000 rpm.
  • Use the S-NS 10 socket.
  • Check that the fastener is the correct model (S-MD 01Z 6.3x19).

Manual page author

Emily Carter

User documentation editor

Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.