IKEA LAPPMES 112mm Birch Handle Assembly Instructions
Step-by-step assembly and installation guide for the IKEA LAPPMES 112mm birch handle, including drilling requirements and mounting instructions.
Table of contents
Product Overview
The IKEA LAPPMES is a 112mm birch handle designed for furniture doors and drawers. This guide provides the necessary steps to ensure proper installation on your furniture piece.
Required Tools
To install the handle, you will need a screwdriver and a power drill with a 5 mm (3/16") drill bit. Ensure you have the provided mounting hardware (part number 119976) before beginning the installation.
Installation Procedure
The installation process requires precision to ensure the handle fits correctly. First, mark the drilling points on your furniture surface. The distance between the two holes must be exactly 96 mm (3 3/4"). Use the 5 mm drill bit to create the holes at the marked locations. Once the holes are prepared, align the handle with the holes from the front and secure it using the provided screws from the inside of the door or drawer panel. Tighten the screws firmly, but be careful not to overtighten to avoid damaging the wood or the handle finish.
Manufacturer information
IKEA
Practical help
Common problems
Check if the screws are fully tightened from the inside of the furniture panel. Ensure the hole diameter is exactly 5 mm.
Verify that the distance between the center of the two drilled holes is exactly 96 mm before proceeding with the installation.
Before use
- Verify you have a 5 mm (3/16") drill bit
- Ensure you have a screwdriver compatible with the provided screws
- Measure and mark the 96 mm distance accurately on the furniture surface
- Check that the furniture panel is suitable for drilling
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.