IKEA TRÅDFRI 10W LED Driver User Manual
Learn how to install, pair, and reset your IKEA TRÅDFRI 10W LED driver for smart lighting control. Includes technical specifications and safety guidelines.
Table of contents
Product Overview
The IKEA TRÅDFRI 10W LED driver is a component designed to power and control LED lighting systems. It allows for basic ON/OFF functionality when connected to mains power, but requires a separate steering device (such as a remote control) to enable dimming and integration with the IKEA Home smart ecosystem.
Steering and Pairing
To control your lighting wirelessly, you must pair the driver with a steering device. Ensure the driver is connected to mains power and turned on. Locate the pairing symbol on the driver enclosure. Hold your steering device within 5 cm of this symbol and press and hold the pairing button on the device for at least 10 seconds. A steady red light on the steering device and a dimming/flashing sequence on the light indicate a successful pairing.
Factory Reset
If the driver becomes unresponsive or you need to un-pair it from a steering device, you can perform a factory reset. Locate the small button marked RESET on the driver enclosure. Use a paperclip or similar tool to gently press and hold the button until the unit resets.
Safety and Maintenance
This product is intended for indoor use only within a temperature range of 5 °C to 45 °C. Avoid placing the unit in direct sunlight or near heat sources to prevent overheating. Do not attempt to repair the unit yourself, as opening the casing may expose you to dangerous voltage. Clean the unit only with a dry, soft cloth; do not use chemical solvents or abrasive cleaners.
Technical Specifications
The driver operates on 220-240 VAC, 50/60 Hz input and provides a 24.0 VDC output with a maximum load of 10.0 W (0.42 A). The wireless radio range is approximately 10 meters in open air, operating on the 2405-2480 MHz frequency band with an output power of 8 dBm.
Manufacturer information
IKEA
Practical help
Common problems
Perform a factory reset by pressing the small button marked RESET on the driver enclosure using a paperclip.
Note that the 10m range is measured in open air; building materials and the placement of units can significantly reduce this distance.
Before use
- Ensure the driver is connected to a mains power source.
- Verify that the mains power switch is turned ON.
- Have a compatible IKEA steering device ready for pairing.
- Ensure the environment temperature is between 5 °C and 45 °C.
- Keep the steering device within 5 cm of the pairing symbol during the setup process.
Specs in practice
- Max total load
- The maximum power capacity of 10.0 W (0.42 A) that the driver can support.
- Operating frequency
- The 2405-2480 MHz band used for wireless connectivity with smart devices.
Model compatibility
- Requires a separate steering device for dimming and smart home integration.
- Compatible with IKEA Home smart app when used with TRÅDFRI gateway or DIRIGERA hub.
- Suitable for use as a dimmer for LED light sources.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.