Electronics / Televisions
IKEA TRÅDFRI 10W LED Driver User Manual
Learn how to install, pair, and reset your IKEA TRÅDFRI 10W LED driver for wireless lighting control. Includes technical specifications and safety guidelines.
Table of contents
Product Overview
The IKEA TRÅDFRI 10W LED driver is a wireless control unit designed to manage lighting systems. It allows for ON/OFF switching and dimming when paired with a compatible IKEA steering device (such as a remote control) or integrated into the IKEA Home smart ecosystem via the TRÅDFRI gateway or DIRIGERA hub.
Pairing a Steering Device
To pair the driver with a steering device:
- Ensure the LED driver is connected to mains power and turned ON.
- Hold your steering device within 5 cm of the pairing symbol on the LED driver.
- Press and hold the pairing button on the steering device for at least 10 seconds.
- A red LED on the steering device will shine steadily, and the connected light will dim and flash once to confirm successful pairing.
Factory Reset
If the product becomes unresponsive or you wish to unpair it from a steering device, perform a factory reset. Locate the small button marked RESET on the driver enclosure. Use the tip of a pen to gently press and hold the button.
Safety and Maintenance
This device is intended for indoor use only in temperatures between 5°C and 45°C. Avoid placing the unit in direct sunlight or near heat sources to prevent overheating. Clean the unit only with a dry, soft cloth; do not use abrasive cleaners or chemical solvents. Do not attempt to repair the unit yourself, as opening the casing may expose you to dangerous voltage.
Manufacturer information
IKEA
Practical help
Common problems
Product does not respond or needs to be unpaired
Perform a factory reset by pressing the small button marked RESET on the driver enclosure using the tip of a pen.
Wireless connectivity range is poor
The range is measured in open air. Building materials and the placement of units can significantly affect the signal; try repositioning the devices.
Before use
- Ensure the LED driver is connected to a mains power source.
- Verify that the mains power is switched ON.
- Have a compatible IKEA steering device ready for pairing.
- Ensure you are within 5 cm of the pairing symbol during the pairing process.
Specs in practice
- Max total load
- 0.42 A, 10.0 W
- Operating frequency
- 2405-2480 MHz
Model compatibility
- Requires a separate steering device (e.g., remote control) for dimming or smart home integration.
- Compatible with IKEA Home smart app via TRÅDFRI gateway or DIRIGERA hub.
- Not for use with third-party devices in a wireless mesh network.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.