Installation Guide for Philips TrueForce Core LED Road Lamp
Quick installation guide for the Philips TrueForce Core LED road lamp. Learn how to safely convert your luminaire to direct mains, remove electronic gear, and install the lamp correctly.
Table of contents
Important Installation Information
This guide provides instructions for installing the Philips TrueForce Core LED road lamp. Before beginning, ensure you are a qualified professional. Always switch off the power supply before commencing work.
Key Requirements:
- The product is for Direct Mains operation only.
- Remove all existing electronic gear, igniters, and capacitors from the luminaire.
- The product is not dimmable.
- Operating temperature range is -30°C to +45°C.
- The lamp is IP65 rated, but must be installed in a luminaire with a suitable IP rating for outdoor use.
Installation Steps
- Switch off the power supply.
- Open the luminaire housing.
- Remove the existing EM gear (igniter and capacitor) and connect the lamp directly to the L and N lines.
- Install the lamp into the E27/E40 holder.
- Apply the warning sticker to the luminaire.
- Switch on the power supply.
Safety Warnings
Do not change the structure or components of the product. Do not use in open luminaires, emergency luminaires, or explosive-proof luminaires. Do not stare directly at the operating light source.
Manufacturer information
Philips
Practical help
Common problems
Ensure the igniter and capacitor (EM gear) have been removed and the lamp is connected to direct mains.
The product is not dimmable; do not use with dimmers.
Before use
- Switch off the power supply before starting.
- Ensure the luminaire is compatible with E27/E40 holders.
- Verify the operating temperature is between -30°C and +45°C.
- Check that the luminaire provides the required IP65 rating.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.