findmanualpdf.com

Installation Guide for QuickBOLT 17667SS Low Profile QB1

Quick guide for installing the QuickBOLT 17667SS Low Profile QB1 solar mount. Includes required materials, step-by-step installation instructions, and torque specifications for asphalt, EPDM, and TPO roofs.

Quick answers from the manual

Quick answer

  • The QuickBOLT 17667SS is installed by predrilling into the rafter, applying sealant, and securing the mount with the Microflashing washer and bolt, requiring a minimum torque of 125 lbs/inch. p. 2

Key actions

  • Drill a hole into the rafter using a 3/16 inch bit. p. 2
  • Apply sealant to the predrilled hole and around the bottom of the Microflashing washer. p. 2
  • Tighten the bolt to a minimum of 125 lbs/inch. p. 2

Technical specifications

Parameter Value Meaning Pages
Minimum Torque 125 lbs/inch Required for proper Microflashing compression p. 2

Where to find it in the PDF

  • Cover Page p. 1
  • Installation Instructions p. 2
Table of contents

Quick guide from the manual

This document provides installation instructions for the QuickBOLT 17667SS Low Profile QB1 mount, designed for use on asphalt, EPDM, and TPO roofs. Proper installation requires specific tools and adherence to torque specifications to ensure a secure, sealed mount.

  • Rafter locator
  • Chalk or a crayon
  • Drill with a 3/16 inch drill bit
  • MFG approved sealant
  • M6 deep socket hex driver
  • 1/2 inch wrench

Installation Instructions

Step 1: Locate the rafter and predrill the hole.
Step 1: Locate the rafter and predrill the hole.
  1. Locate the rafter and predrill the hole.
  2. Fill the predrilled hole with MFG approved sealant.
  3. Place a ring of sealant around the bottom of the Microflashing washer.
  4. Place the Microflashing and drive the bolt until it compresses.
  5. Insert the L-Foot.
  6. Insert the nut and tighten until secure.

Important Notes

To compress the Microflashing properly with the QuickBOLT, use a minimum torque of 125 lbs/inch.

Practical help

Before use

  • Locate the rafter using a rafter locator
  • Mark the position with chalk or a crayon
  • Prepare a drill with a 3/16 inch bit
  • Ensure you have MFG approved sealant
  • Have an M6 deep socket hex driver and 1/2 inch wrench ready

Specs in practice

Minimum Torque
125 lbs/inch is required to properly compress the Microflashing washer for a secure seal.

Manual page author

David Miller

Documentation analyst

Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.