Taramps T 2200SW Subwoofer User Manual
Access the official technical specifications and installation guidelines for the Taramps T 2200SW 12-inch subwoofer. This guide includes Thiele-Small parameters, recommended enclosure volumes, and physical dimensions.
Quick answers from the manual
Quick answer
- The Taramps T 2200SW is a 12-inch, 4 Ohm subwoofer with 1100W RMS power. It is designed for use in a 45-liter vented enclosure tuned to 39 Hz. p. 1
Key actions
- Build a vented enclosure with 45L volume, 2 ducts of 3-inch diameter, and 250mm depth. p. 1
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| RMS Power | 1100 W | Continuous power handling | p. 1 |
| Nominal Impedance | 4 Ohms | Electrical resistance | p. 1 |
| Frequency Response | 22Hz to 900Hz | Range of frequencies the speaker can reproduce | p. 1 |
Show 1 more answers Show less
Where to find it in the PDF
- Technical Specifications and Cabinet Guidelines p. 1
Table of contents
Quick guide from the manual
The Taramps T 2200SW is a 12-inch subwoofer designed for high-performance low-frequency reproduction. This document provides the essential technical data, Thiele-Small parameters, and enclosure recommendations required for proper installation in car audio or home theater systems.
Cabinet suggestions
To achieve the best performance, the manufacturer recommends a vented enclosure configuration. Ensure your build adheres to the following specifications:
- Volume: 45 Liters
- Ducts Quantity: 2
- Duct Diameter: 3 inches (approx. 250 mm)
- Tuning Frequency (Sintony): 39 Hz
- High Pass Filter (H.P.F): 25 Hz
- Attenuation: 12 dB/Octave
Technical specifications
The following parameters are critical for system integration and amplifier matching:
- RMS Power: 1100 W
- Musical Program Power: 2200 W
- Nominal Impedance: 4 Ohms
- Sensitivity: 86.45 dB (@ 1W, 1m)
- Frequency Response: 22 Hz to 900 Hz
- Resonance Frequency: 36.63 Hz
- Total Q (Qts): 0.519
Physical dimensions
When planning your installation, consider the following physical dimensions of the subwoofer:
- Total Diameter: 324 mm (12.75 in)
- Total Height: 161 mm (6.33 in)
- Weight: 21.45 lb (9.73 Kg)
- Volume Occupied on Cabinet: 3.7 Liters
Practical help
Before use
- Verify that your amplifier is stable at 4 Ohms impedance.
- Construct a vented enclosure with a net internal volume of 45 Liters.
- Ensure the enclosure ducts are 3 inches in diameter and 250 mm deep.
- Set your amplifier's High Pass Filter (H.P.F) to 25 Hz to protect the subwoofer.
- Check that the mounting surface can support the 9.73 Kg weight of the speaker.
Specs in practice
- Nominal Impedance
- 4 Ohms - The electrical resistance of the voice coil, critical for amplifier matching.
Manual page author
Michael Turner
Technical manual editor