Tecnolite 16YDLED015MVCCB LED Downlight
Quick guide for the Tecnolite 16YDLED015MVCCB LED Downlight. Learn how to install, adjust color temperature, and maintain your recessed lighting fixture.
Quick answers from the manual
Quick answer
- This manual provides installation, safety, and maintenance instructions for the Tecnolite 16YDLED015MVCCB LED Downlight. p. 1
Key actions
- Cut a hole in the ceiling between 75mm and 160mm in diameter. p. 1
- Connect the electrical wires according to the provided electrical diagram. p. 1
- Insert the luminaire into the ceiling opening. p. 1
First start
- Cycle the power switch to change the color temperature: Switch on x1 (3000K), x2 (4000K), x3 (6000K). p. 1
Maintenance and reset
- Disconnect the power source and clean the luminaire and its internal parts with a dry rag. p. 1
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Voltage | 100 V ~ 240 V | Operating voltage range | p. 1 |
| Frequency | 50 Hz/60 Hz | Operating frequency | p. 1 |
| Power | 16 W | Power consumption | p. 1 |
| Current | 0.16 A - 0.06 A | Input current | p. 1 |
Where to find it in the PDF
- Installation and Specifications p. 1
- Warranty Information p. 2
Table of contents
Quick Guide
The Tecnolite 16YDLED015MVCCB is an indoor LED downlight featuring a 12W main light and a 4W night light ring. It requires a ceiling cutout between 75mm and 160mm and must have at least 25cm of ventilation space above the fixture to prevent overheating.
Installation
Follow these steps to install the downlight:
- Prepare the Cutout: Create a hole in the ceiling with a diameter between 75mm and 160mm. Ensure there is at least 25cm of ventilation space above the fixture.
- Wiring: Disconnect the power supply. Connect the Line and Neutral wires according to the electrical diagram.
- Mounting: Adjust the spring clips to fit the cutout size and insert the fixture into the ceiling.
Operation
The color temperature can be adjusted by toggling the light switch:
- Switch x1: 3000K (Warm Light)
- Switch x2: 4000K (Neutral Light)
- Switch x3: 6000K (Daylight)
Safety and Maintenance
Safety: For indoor use only. Do not install near combustible materials. Ensure the power is disconnected before performing any installation or maintenance work.
Maintenance: Clean the fixture and its internal parts with a dry rag. Ensure the fixture has cooled down before handling.
Manufacturer information
Tecnolite
Practical help
Common problems
Check the power supply and ensure all electrical connections are secure.
Ensure there is at least 25cm of ventilation space above the fixture.
Before use
- Verify the ceiling cutout diameter is between 75mm and 160mm.
- Ensure the power supply is disconnected before starting installation.
- Check that the installation location is not near combustible materials.
- Confirm there is at least 25cm of ventilation space above the fixture.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.