Uniden BC 120XLT Twin Turbo Scanner Operating Guide
Quick guide for the Uniden BC 120XLT Twin Turbo Scanner, covering battery charging, channel programming, scanning modes, and troubleshooting.
Table of contents
Quick guide from the manual
The Uniden BC 120XLT is a 100-channel programmable scanner. Before first use, ensure the battery pack is fully charged. The device features Twin Turbo technology for fast scanning and searching across 11 frequency bands. Key operations include programming channels manually, using preprogrammed service scans, and searching for active frequencies.
Setup
Battery Charging: Connect the AD-70U AC adapter to the charging jack on the left side of the scanner. A full charge takes 14 to 16 hours. Use only the specified adapter to avoid damage.
Antenna and Belt Clip: Attach the rubber antenna to the BNC connector on top by turning it clockwise. Install the belt clip on the back using the provided screws, being careful not to overtighten.
Operation
Scanning: Press SCAN to monitor programmed channels. You can toggle banks on or off to customize the scan cycle. Use the SQUELCH control to eliminate background noise until the threshold is reached.
Programming Channels: To store a frequency, press MAN, enter the channel number, type the frequency using the numeric keypad (including the decimal point), and press E to save.
Searching: Press SRCH to search for active frequencies within a specified range. You can set frequency limits by pressing LIMIT after entering the start and end frequencies.
Maintenance and Safety
Cleaning: Use a mild detergent and a soft cloth. Do not use abrasive cleaners or excessive water. Keep the device away from high-moisture environments and direct sunlight.
Battery Care: The scanner uses a Nickel-Cadmium battery. Do not short-circuit or dispose of it in fire. If the low battery indicator blinks, the unit will shut off after approximately 10 minutes to prevent deep discharge.
Practical help
Common problems
Check power connections, volume/squelch settings, and ensure the power switch is on.
Check antenna connection or reposition the scanner to a higher elevation.
Adjust the Squelch control or check if any frequencies are programmed.
Check if the keypad lock is active.
Before use
- Fully charge the battery pack for 14-16 hours.
- Attach the rubber antenna securely.
- Ensure the squelch control is initially set fully clockwise.
- Verify that the battery pack is installed with correct polarity.
Specs in practice
- Operating Temperature
- -20°C to +60°C (-5°F to +140°F).
Model compatibility
- Use only AD-70U AC adapter or approved cigarette lighter power cords.
- Use only 32-ohm impedance earphones or headsets.
- Frequency coverage is not continuous from 29.0 MHz to 512 MHz.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.