Tools / Power Tools
Bosch 18V-200 C Cordless Impact Driver User Manual
Quick guide for the Bosch 18V-200 C Cordless Impact Driver, covering assembly, battery charging, tool operation, safety instructions, and technical specifications.
Table of contents
Quick guide from the manual
This manual provides essential information for the safe and efficient operation of the Bosch 18V-200 C Cordless Impact Driver. It covers setup, battery management, and operational guidelines for driving and loosening screws and nuts.
Device Description
The tool features a tool holder, a rotational direction switch, speed preselection, and an integrated LED light. It is designed for driving and loosening screws and nuts within the specified dimensions.
Assembly and Battery Charging
Always remove the battery before performing any maintenance, changing tools, or transporting the device to prevent accidental activation. Use only the chargers listed in the technical data. The battery is supplied partially charged; fully charge it before the first use.
Operation
The tool operates via an electric motor, gear, and impact mechanism. The working procedure consists of two phases: screwing and tightening. The impact mechanism activates when the screw connection becomes tight and the motor is under load.
Settings and Modes
You can preselect the speed/impact rate in three stages using the dedicated button. The rotational direction can be adjusted using the switch, but not while the on/off switch is pressed.
Maintenance and Cleaning
Regularly clean the tool holder and locking sleeve, and lightly grease them with the specified grease. Keep the ventilation slots clean to ensure safe and efficient operation.
Safety
Always wear personal protective equipment, including eye protection. Hold the tool by insulated gripping surfaces when performing operations where the fastener may contact hidden wiring. Do not use the tool in explosive atmospheres.
Technical Data
The tool operates at 18V. It features three speed/impact settings, with a maximum torque of 200 Nm. It is compatible with GBA 18V and ProCORE18V batteries.
Manufacturer information
Bosch
Practical help
Common problems
Tool does not start
Check if the battery is charged and correctly inserted. Ensure the rotational direction switch is not in the middle position.
Battery charge indicator does not light up
The battery may be defective and needs to be replaced.
Application tool comes off during operation
Ensure the application tool is securely connected to the tool holder.
Before use
- Ensure the battery is fully charged.
- Check that the correct bit is securely inserted into the tool holder.
- Set the rotational direction switch to the desired position.
- Select the appropriate speed/impact setting for the material.
- Wear appropriate personal protective equipment (eye protection, etc.).
Specs in practice
- Rated Voltage
- 18V, the required voltage for the tool.
Model compatibility
- Compatible with Bosch GBA 18V and ProCORE18V batteries.
- Compatible with chargers GAL 18..., GAX 18..., and GAL 36...
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.