Instruction Manual for allen + roth FSI 1168Q Double Curtain Rod

Quick guide for installing the allen + roth FSI 1168Q double curtain rod. Includes step-by-step mounting instructions, hardware list, and troubleshooting tips for leveling and securing the rod.

Table of contents

Quick guide from the manual

This document provides installation and maintenance instructions for the allen + roth FSI 1168Q double curtain rod. Before beginning, ensure all parts are present and undamaged. The estimated assembly time is 30 minutes. Required tools (not included) include a drill, a 3/16-inch drill bit, a level, and a screwdriver.

Package contents

3 x Rod brackets (AA)
6 x Screws (BB)
6 x Wall anchors (CC)
2 x Large diameter rods (A)
2 x End caps (B)
3 x Smaller diameter rod sections (C)
2 x Additional rod components (D)

Installation

Marking: Use a bracket as a guide to mark the desired height and screw locations on the wall.
Drilling: Remove the bracket, drill pilot holes using a 3/16-inch bit, and insert wall anchors if necessary.
Mounting: Attach the brackets to the wall using the provided screws. Repeat for all brackets, using a level to ensure alignment.
Assembly: Extend the telescopic rod slightly and remove the end cap from the smaller diameter section.
Connecting: Slide the additional rod section over the smaller diameter rod.
Placement: Feed the curtain panels onto the rod. Extend the rod through the center and outside brackets, then reattach the end caps.
Securing: Tighten all set screws on the brackets to lock the rod in place.

Care and maintenance

Clean the product using a soft cloth. Avoid using abrasive cleaning agents, solvents, or polishes, as these may damage the finish.

Troubleshooting

Rod not level: Ensure the drapery hooks are installed correctly and use a level during installation.
Rod hook is loose: Ensure hooks are anchored correctly into wall studs if possible. If not, use the provided anchors and screws.

Practical help

Common problems

Drapery rod is not level

Ensure the drapery hooks are installed correctly and use a level during the installation process.

Drapery rod hook is loose

Ensure hooks are anchored into wall studs if possible. If not, use the provided anchors and screws.

Before use

Verify all parts are present against the package contents list.
Check for any missing or damaged parts before starting.
Ensure you have a drill, 3/16-inch drill bit, screwdriver, and level ready.
Determine if wall studs are available for mounting or if anchors are required.

Specs in practice

Estimated Assembly Time: Approximately 30 minutes for a standard installation.
Drill Bit Size: 3/16-inch bit is required for pilot holes when using wall anchors.

Images and diagrams

The manual provides a visual sequence from step 1 to 7 showing the bracket mounting, rod assembly, and final securing process.
Diagrams illustrate the correct orientation of the telescopic rod sections and the placement of end caps.

Model compatibility

Anchors are not needed for all installation types (e.g., if mounting directly into wall studs).
Curtains are sold separately.

Show more Show less

Manual page author

David Miller

Documentation analyst

Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.