User Manual for Walmart 16MP Portable Camcorder

Quick guide from the manual

To ensure your camcorder functions correctly, please follow these essential setup steps before use:

• SD Card: Always insert the memory card before powering on the device.
• Batteries: Use three AAA alkaline batteries and ensure they are installed with the correct polarity.

Device features

This video recorder is equipped with a 16 Mega Pixels CMOS sensor (by interpolation). It supports video recording in the following resolutions:

• 1080P (1920x1080) at 30fps
• 720P (1280x720) at 30fps
• VGA (640x480)

Installation

SD memory card

The SD memory card must be inserted before the device is powered on if you intend to record video or take photos. If the device fails to detect the SD card, ensure it is inserted correctly while the device is powered off.

Battery installation

The device requires three AAA alkaline batteries. Follow these steps to install them:

1. Slide down the battery cover to open and remove it.
2. Insert three AAA alkaline batteries, paying close attention to the polarity signs (+/-) located on the terminals.
3. Close the battery compartment by sliding the leading end of the cover into the latch and pressing down to secure it.

Safety warnings

Important: Reverse installation of the anode (positive) and cathode (negative) terminals may lead to damage to the video recorder or cause a fire accident. Always verify the orientation before closing the battery cover.