User Manual for WiZ Wi-Fi LED Strip 2M Starter Kit

Quick Guide for WiZ Wi-Fi LED Strip

This guide covers the installation and safety requirements for the WiZ Wi-Fi LED Strip 2M Starter Kit. Ensure you follow the cutting and bending guidelines to prevent damage to the product.

Installation Steps

1. Clean the surface where the strip will be mounted to ensure proper adhesion.
2. Peel the backing from the adhesive strip and press firmly onto the surface.
3. Connect the light strip to the controller, ensuring the polarity is correct (aligning the connectors).
4. Plug the power adapter into a wall outlet.

Cutting and Bending Guidelines

• Cutting: Only cut the strip at the designated sections marked with scissor icons.
• Bending: Maintain a minimum bending radius of 20mm (R20mm) and a minimum angle of 90 degrees. Do not fold the strip sharply.

Safety and Operating Conditions

• Operating Temperature: -4°F to +95°F (-20°C to +35°C).
• Maximum Length: Do not exceed 33 feet (10 meters) connected to a single Wi-Fi controller.
• Usage: Suitable for damp locations. Not intended for use with emergency exit lights.
• Dimming: This lamp will not operate properly when connected to a standard (incandescent) dimmer or dimming control device.
• Safety: The power plug is polarized; if it does not fit, contact a qualified electrician. Do not use extension cords unless the plug can be fully inserted.