Tools / Power Tools
Bosch 185-LI Professional Cordless Drill/Driver Instruction Manual
Quick guide for the Bosch 185-LI Professional cordless drill/driver, covering battery installation, tool changing, operating modes, and safety instructions.
Table of contents
Manual images
Jump to the sectionQuick guide from the manual
This manual provides essential information for the safe and efficient operation of the Bosch 185-LI Professional cordless drill/driver. Always remove the battery before performing maintenance, changing tools, or transporting the device to prevent accidental activation.
Device Description
The tool is designed for driving and loosening screws and for drilling in wood, metal, ceramic, and plastic. The GSB model also supports impact drilling in brick, masonry, and stone.
Operation
Inserting the battery: Push the charged battery into the base of the tool until it locks securely.
Changing the tool: The drill spindle is locked when the on/off switch is not pressed, allowing for quick and easy tool changes. Open the keyless chuck by turning it in the direction of rotation 1, insert the tool, and tighten the chuck firmly by hand in the direction of rotation 2.
Setting the rotational direction: Use the rotational direction switch only when the tool is at a standstill. Press to the left for right rotation (drilling/screwing) and to the right for left rotation (loosening screws/nuts).
Operating modes: Use the torque presetting ring (GSR) or the operating mode presetting ring (GSB) to select between drilling, screwdriving, and impact drilling (GSB only).
Safety
Always wear ear protection when impact drilling. Hold the tool by insulated gripping surfaces when performing operations where the cutting accessory or fasteners may contact hidden wiring. Avoid dust accumulation at the workplace, as dust can easily ignite.
Maintenance and Cleaning
Keep the power tool and ventilation slots clean for safe and efficient operation. For repairs or spare parts, contact your local Bosch service center or visit www.bosch-pt.com.
Official resources from the manual
Manufacturer information
Bosch
Practical help
Common problems
Tool does not start
Check if the battery is charged and correctly inserted.
Low battery indicator (flashing LED)
Charge the battery or replace it with a fully charged one.
Tool stops during operation
Device protection is active due to high current consumption or overheating. Allow the tool to cool down.
Before use
- Ensure the battery is fully charged.
- Check that the correct tool bit is inserted and the chuck is tightened.
- Verify the correct rotational direction is set.
- Ensure the operating mode is set correctly for the task.
- Check that the work area is clean and well-lit.
Specs in practice
- Rated voltage
- 18V, indicating the battery system compatibility.
- No-load speed
- 0-500 min-1 (1st gear) and 0-1900 min-1 (2nd gear) for different drilling/screwing needs.
- Max. torque (hard)
- 50 Nm, the maximum force for driving screws into hard materials.
Images and diagrams
- (1) Tool holder
- (2) Keyless chuck
- (3) Torque presetting ring
- (5) Gear selector switch
- (9) Rotational direction switch
Model compatibility
- Compatible with all Bosch GBA 18V and ProCORE18V batteries.
- Use only chargers listed in the technical data.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.