Tools / Power Tools
Bosch GNH 18V-64-2 Cordless Wood Nailer User Manual
Quick guide for the Bosch GNH 18V-64-2 series cordless wood nailers. Includes instructions for magazine loading, depth adjustment, clearing jams, and troubleshooting.
Table of contents
Quick guide from the manual
This document provides essential operating instructions for the Bosch GNH 18V-64-2, GNH 18V-64-2 M, and GNH 18V-64 MD cordless wood nailers. These tools are designed for driving nails into wood only and are not suitable for metal or concrete.
Loading the magazine
- Remove the battery before loading.
- Clean the magazine slider and ensure the magazine is free of debris.
- Insert a suitable nail strip into the T-slot at the end of the magazine.
- Push the nail strip forward until the last nail is in front of the magazine spring.
- Press the nail pusher against the magazine slider and pull the slider to the end of the magazine.
- Carefully guide the slider forward until it engages with the nail strip.
Operation
Single actuation: The discharge lock-off must be pressed against the workpiece before pulling the trigger. After firing, both must be released before the next shot.
Contact actuation (M and MD models): The trigger is held down, and a nail is fired each time the discharge lock-off is pressed against the workpiece.
Adjusting the depth stop
Use the thumbwheel to adjust the driving depth. Turn towards '-' to reduce depth or '+' to increase depth. Verify the setting on the depth stop indicator and test on a scrap piece.
Clearing jams
- Release the trigger, switch off the tool, and remove the battery.
- Empty the magazine.
- Press the clamping lever down to open the shot duct.
- Remove the jammed nail using pliers if necessary.
- Close the shot duct and secure the clamping lever.
Maintenance
Regularly clean the magazine and the discharge lock-off mechanism using compressed air. If the tool is not working, check the battery charge, ensure it is properly inserted, or check for jammed nails. For persistent issues, contact an authorized Bosch service center.
Manufacturer information
Bosch
Practical help
Common problems
Tool is ready but does not fire nails
Check for jammed nails, ensure the magazine is not empty, or verify that the correct firing sequence is being used.
Nails are driven too deep or not deep enough
Adjust the depth stop thumbwheel. Turn towards '-' for less depth or '+' for more depth.
Frequent jamming in the shot duct
Ensure you are using approved fasteners and that the magazine is clean. If the issue persists, contact service.
Before use
- Ensure the battery is fully charged and properly inserted.
- Check that the magazine is loaded with the correct type of nails.
- Verify that the safety and actuation devices are functioning correctly.
- Ensure all screws and nuts are tightly seated.
- Check that the workpiece is clear of hidden electrical or utility lines.
Specs in practice
- Magazine Capacity
- Maximum of 105 nails can be loaded at once.
- Operating Temperature
- Permitted range is -20°C to +50°C.
Images and diagrams
- The magazine slider (15) and nail pusher (16) are critical for feeding nails.
- The clamping lever (3) allows access to the shot duct for clearing jams.
- The depth stop thumbwheel (5) is located near the shot duct for easy adjustment.
Model compatibility
- Compatible with Bosch GBA 18V and ProCORE18V battery series.
- Not suitable for driving nails into metal or concrete.
- Use only original Bosch accessories for optimal performance.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.