Tools / Power Tools
Bosch EasyDrill | EasyImpact 18V-40 Cordless Drill/Driver User Manual
Quick guide for the Bosch EasyDrill and EasyImpact 18V-40 cordless drill/drivers, covering assembly, operation, tool changes, and safety instructions.
Table of contents
Quick guide from the manual
This document provides essential instructions for the Bosch EasyDrill 18V-40 and EasyImpact 18V-40 cordless drill/drivers. It covers safe operation, assembly, and maintenance. Always remove the battery before performing any maintenance or tool changes to prevent accidental activation.
Device Description
The tools are designed for driving and loosening screws and for drilling in wood, metal, ceramic, and plastic. The EasyImpact 18V-40 model is additionally designed for impact drilling in brick.
Assembly
Charging the Battery: Use only the chargers listed in the technical data. The battery is supplied partially charged; charge it fully before first use.
Changing the Tool: The drill spindle is locked when the on/off switch is not pressed. Open the keyless chuck by turning it in the direction of rotation 1, insert the tool, and firmly tighten the chuck sleeve in the direction of rotation 2 until it stops clicking.
Operation
Inserting the Battery: Set the rotational direction switch to the middle position to prevent accidental starting. Insert the charged battery into the handle until it engages flush.
Setting Rotational Direction: Use the rotational direction switch to change the direction. This is not possible while the on/off switch is pressed.
Switching On/Off: Press and hold the on/off switch to start. Release it to stop. The worklight illuminates the area when the switch is pressed.
Adjusting Speed and Torque: Speed is controlled by the pressure applied to the on/off switch. Torque can be preselected in 20 stages using the torque presetting ring.
Maintenance and Service
Always keep the tool and ventilation slots clean for safe operation. For repairs or spare parts, contact your local Bosch service center or visit www.bosch-pt.com.
Official resources from the manual
Manufacturer information
Bosch
Practical help
Common problems
Tool does not start
Check if the battery is charged and correctly inserted. Ensure the rotational direction switch is not in the middle position.
Tool stops during operation
The tool may be overloaded or the battery temperature is too high. The electronic protection system will switch it off until it cools down.
Chuck does not hold the bit
Ensure the chuck sleeve is tightened firmly in the direction of rotation 2 until no more clicking is heard.
Before use
- Ensure the battery is fully charged.
- Check that the correct tool bit is inserted and the chuck is tightened.
- Set the rotational direction switch to the desired direction.
- Select the appropriate gear (I or II) for the task.
- Set the torque or operating mode (drilling/screwdriving/impact) as required.
Specs in practice
- Rated voltage
- 18V, indicates the battery system compatibility.
- No-load speed
- 0-430 min-1 (1st gear) and 0-1630 min-1 (2nd gear).
- Max. drilling diameter
- Up to 13mm for steel/masonry and 30mm for wood.
Model compatibility
- Compatible with Bosch PBA 18V series batteries.
- Not compatible with AL 1814 CV, AL 1820 CV, AL 1860 CV, or AL 2215 CV chargers.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.