Garden / Outdoor
Gardena 18V Garden Pump User Guide
Quick guide for the Gardena 18V Garden Pump, covering installation, operation, maintenance, and troubleshooting.
Table of contents
Quick guide from the manual
This document provides essential information for the Gardena 18V Garden Pump (Art. 14610). It covers safety, installation, operation, maintenance, and troubleshooting. Always ensure the pump is filled with at least 1.1 liters of water before each startup to prevent dry running.
Product Description
The Gardena Garden Pump is designed for watering, water supply, and cleaning tasks in private gardens. It can draw water from a depth of up to 8 meters.
Installation
1. Place the pump on a level, firm, and dry surface at least 2m away from the water. 2. Ensure ventilation slots are not covered. 3. Connect a vacuum-resistant suction hose to the (In) connection. 4. Connect a pressure hose to the (Out) connection. 5. Fill the pump with at least 1.1 liters of water through the filling opening before startup. 6. Insert the battery until it clicks into place.
Operation
1. Open all shut-off valves in the pressure line. 2. Press the On/Off button on the control panel to start the pump. 3. Use the rotary knob to adjust the pump power. 4. To speed up the priming process, press and hold the On/Off button for 3 seconds to activate the priming mode.
Maintenance
1. Remove the battery before any maintenance. 2. Clean the pump housing with a damp cloth and air vents with a soft brush. 3. Flush the pump after pumping chlorinated water. 4. Clean battery contacts and air vents with a soft, dry brush.
Storage
1. Remove the battery. 2. Drain the pump by opening the water drain plug and tilting the pump by approx. 80°. 3. Store in a dry, enclosed, and frost-proof location.
Troubleshooting
If the pump does not start or stops, check the battery charge, ensure the pump is filled with water, and verify that the suction line is airtight. If the error LED lights up red, check the battery temperature or if the dry-run protection has tripped.
Technical Data
Max. delivery capacity: 3000 l/h. Max. pressure/delivery head: 3.0 bar / 30 m. Max. self-priming level: 8 m. Max. media temperature: 35 °C.
Manufacturer information
GARDENA
Practical help
Common problems
Pump runs but without suction
Check suction line for leaks, ensure the end of the suction hose is submerged, and refill the pump with water.
Pump does not start or stops (Error LED lights up red)
Check battery temperature, ensure the pump is filled with water, and let the control panel cool down if overheated.
Charge cycle not possible
Ensure the charger is correctly attached, clean battery contacts, or check battery temperature.
Before use
- Ensure the pump is on a level, firm, and dry surface.
- Check that the suction hose is vacuum-resistant and airtight.
- Fill the pump with at least 1.1 liters of water.
- Ensure the pressure hose is connected and not kinked.
- Insert a fully charged battery.
Specs in practice
- Max. delivery capacity
- 3000 l/h
- Max. delivery head
- 30 m
- Max. self-priming level
- 8 m
Model compatibility
- Compatible with POWER FOR ALL system batteries (PBA 18V).
- Use only recommended battery chargers (AL 18 series).
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.