Lighting / Controllers & Dimmers
GM Lighting Sure-Tite 10mm Connector Specification Sheet
Quick guide for GM Lighting Sure-Tite 10mm LED tape connectors. Includes compatibility notes for LTR-P and LTR-S series, electrical specifications, and an overview of available connector types.
Table of contents
Quick guide from the manual
The GM Lighting Sure-Tite 10mm connectors are designed to provide a secure, low-profile electrical connection for compatible LED tape lights. These connectors feature screw-in terminals that allow for easy adjustments and re-securing of the tape. They are intended for dry and damp locations only and are not suitable for wet environments or multi-color LED tapes.
Product Overview
Sure-Tite connectors act as a splice box for your LED tape, ensuring a tight and clear electrical connection. The clear construction helps minimize light loss at the connection point.
Compatibility and Limitations
Before installation, ensure your LED tape meets the following requirements:
- Width: Must be 10mm wide.
- Wiring: Must be 2-wire tape.
- Series: Compatible with LTR-P Professional Series and LTR-S Specification Series.
- Color: Single color only.
- Restrictions: NOT for use with tunable white, RGB, RGBW, or RGBTW tapes.
- Environment: Dry and damp locations only. Do not use in wet locations.
Available Models
- ESTC-1: Tape to tape connector.
- ESTC-90: 90° Tape to tape connector.
- ESTLK-60: 60" Tape to tape connector.
- ESTW-60: 60" Tape to power connector.
- ESTW-CO: Tape to power supply connector (no wire).
Specifications
- Amp Rating: 6A max.
- Voltage: 12V / 24V.
- Wire Compatibility: Up to 14AWG wire.
- Warranty: 5 years.
Practical help
Common problems
Incompatible LED tape type
Ensure your tape is 10mm wide and 2-wire. These connectors do not support RGB, RGBW, or tunable white tapes.
Connector used in wet location
These connectors are rated for dry/damp locations only. Do not install in wet locations.
Before use
- Verify LED tape width is 10mm
- Confirm tape is 2-wire (single color)
- Check that the installation environment is dry or damp
- Ensure wire gauge is 14AWG or smaller
Images and diagrams
- ESTC-1: Standard straight tape-to-tape connection.
- ESTC-90: 90-degree corner tape-to-tape connection.
- ESTW-60: Connection from tape to power source using a 60-inch wire.
- ESTW-CO: Direct tape-to-power supply connector without wire.
Model compatibility
- Compatible with LTR-P and LTR-S series.
- Not for use with tunable white, RGB, RGBW, or RGBTW tapes.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.