Tools / Power Tools
Bosch GDS 18V-1000 Professional Cordless Impact Wrench User Guide
Quick guide for the Bosch GDS 18V-1000, 18V-1050 H, 18V-1000 C, and 18V-1050 HC cordless impact wrenches, covering assembly, operation, settings, and maintenance.
Table of contents
Manual images
Jump to the sectionQuick guide from the manual
This manual provides essential operating instructions for the Bosch GDS 18V-1000, 18V-1050 H, 18V-1000 C, and 18V-1050 HC cordless impact wrenches. Always remove the battery before performing any maintenance or tool changes to prevent accidental startup.
Device Description
The tool features a tool holder (1), rotational direction switch (2), and an on/off switch (8). Models with 'C' or 'HC' suffix include a user interface (7) for speed preselection and mode selection. The tool is designed for driving and loosening screws and bolts.
Assembly
To change the tool, remove the battery and slide the application tool (10) onto the square drive of the tool holder (1). Ensure the tool is securely connected. The ladder clip (4) can be attached to the tool; ensure the screw is tightened to 2.0–2.5 Nm.
Operation
The tool operates in two phases: screwing and tightening (impact mechanism). The impact mechanism activates when the screw connection becomes tight. Set the rotational direction using switch (2). Speed and impact rate are controlled by the pressure applied to the on/off switch (8).
User Interface (C/HC models)
The user interface (7) allows for speed preselection (16) and working mode selection (14). Status indicators (11) provide feedback: green (OK), yellow (critical temperature/low battery), red (overheated/empty battery), and blue (Bluetooth connection).
Maintenance and Cleaning
Regularly clean the air vents to prevent dust accumulation. Always remove the battery before any maintenance. For service, contact Bosch professional service centers.
Manufacturer information
Bosch
Practical help
Common problems
Tool does not start
Check battery charge status and ensure the battery is correctly inserted.
Tool overheated or battery empty
Allow the tool to cool down or replace/charge the battery.
Application tool falls off
Ensure the tool is securely connected to the square drive of the tool holder.
Before use
- Ensure the battery is fully charged.
- Check that the correct impact-resistant bit or socket is attached.
- Verify the rotational direction switch is set correctly.
- Ensure the tool is placed on its side, not on the battery, to prevent tipping.
Specs in practice
- Rated voltage
- 18V DC for all models.
- Max. tightening torque
- 1000 Nm (1000/1000 C) or 1050 Nm (1050 H/HC).
Images and diagrams
- Page 3/4: Overview of tool components including tool holder, switch, and user interface.
- Page 5: Tool change procedure for different square drive sizes.
- Page 6: User interface layout and ladder clip installation.
Model compatibility
- Compatible with GBA 18V and ProCORE18V batteries.
- Bluetooth connectivity available for C and HC models via GCY 42 module.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.