User Manual for DJO Aircast XP Walker Extra Pneumatic

Quick guide from the manual

The Aircast XP Walker Extra Pneumatic is designed to provide support and immobilization for the lower leg, ankle, and foot. Proper application is critical for the device to function correctly. Always consult with your healthcare professional regarding the frequency and duration of use.

Intended use and indications

This device is intended for use following stable ankle and/or foot fractures and severe lateral ankle sprains. It provides immobilization or controlled movement of the limb or body segment. It is contraindicated for unstable fractures of the lower leg, ankle, and foot.

Warnings and precautions

• Supervision: This device must be used under the supervision of a healthcare professional.
• Skin irritation: Do not over-inflate aircells. If you notice skin changes or discomfort, reduce the pressure.
• Sensation: Patients without sensation (e.g., post-op anesthesia, neuropathies) should be monitored frequently for skin damage or irritation.
• High altitude: Aircells will expand beyond their optimal level at high altitudes. Adjust support by tightening or loosening straps.
• Circulation: Do not over-tighten straps, as this may reduce blood flow or sensation.

Application instructions

Follow these steps to apply the brace correctly:

1. Prepare the brace: Unfasten all straps, remove the front panel, and open the toe cover and foot flaps.
2. Apply the brace: Put on the sock included with the brace. While seated, place your leg in the brace and seat your heel against the back. Wrap the foot flaps over the foot and the toe cover around your toes. Secure the front panel with the lower part inside the brace and the upper part outside the brace.
3. Secure straps: Secure the straps starting from the bottom and working your way up. Tighten until the fit is snug and comfortable.

Adjusting aircell support

The pneumatic aircells are initially deflated. To inflate:

• Firmly insert the "inflate" tip of the hand bulb into the brace valve.
• Cover the hand bulb pressure-relief valve with your finger.
• Squeeze the hand bulb several times until the aircell feels snug.
• With the bulb still in the valve, lift your finger from the pressure-relief valve for 3 to 5 seconds, then withdraw the bulb.

If the aircells are over-inflated, insert the "deflate" tip of the hand bulb into the valve and squeeze several times until the desired compression is reached.

Care and maintenance

The foam liner may be hand-washed in cold water with a mild detergent and air-dried. Do not use the device if it is damaged or the packaging has been opened.