Plumbing / Bathroom Accessories
Installation Instructions for Taymor 01-C230018BLK Concealed Mount Grab Bar
A comprehensive installation guide for the Taymor 01-C230018BLK concealed mount grab bar. Includes step-by-step mounting procedures, required tools, and essential safety requirements for secure installation.
Table of contents
Quick guide from the manual
Before beginning the installation, ensure that your wall blocking or backing complies with local municipal building codes. The structural strength of the grab bar depends entirely on the anchors and the wall backing used. Please note that concealed anchor devices are not included with the Taymor grab bar and must be purchased separately as an accessory. Always secure the mounting flanges to studs or backing using three screws per flange.
Tools required
- Pencil
- Measuring Tape
- Phillips Screwdriver
- Level
- Power Drill
- 1/8 inch Drill bit
- Silicone Sealant
Installation
- Removing the escutcheon: Loosen the escutcheons from the grab bar base by gently tapping from the back.
- Positioning the grab bar: Place the grab bar on the wall at the desired location. Use a level to ensure the bar is plumb.
- Marking the installation location: Use a pencil to mark the mounting hole locations on the wall.
- Drilling the mounting holes: Remove the grab bar from the wall and carefully drill pilot holes at the marked locations.
- Installing the grab bar: Install the grab bar using the accompanying screws. Ensure all screws are securely tightened.
- Securing the grab bar: Slide the escutcheons onto the grab bar until they reach the mounting plates. Align the three dimples on the side of the escutcheons with the three protrusions on the mounting plates and push until they snap into place.
Safety and maintenance
For best practices and to protect against water penetration, apply silicone in the drilled holes and use caulking at the joint where the escutcheon meets the wall. Ensure the grab bar is firmly secured to support the intended loads.
Practical help
Common problems
Missing mounting hardware
Concealed anchor devices are not provided with the grab bar and must be purchased separately.
Weak installation
Grab bar strength is dependent on the anchors and wall backing; ensure the bar is firmly secured to studs or proper blocking.
Before use
- Verify wall blocking or backing meets municipal building codes.
- Purchase appropriate concealed anchor devices separately.
- Gather all required tools: drill, level, screwdriver, and silicone.
- Ensure the installation surface is prepared before installing wall sheathing.
Specs in practice
- Mounting requirement
- Must use three (3) screws per flange.
- Water protection
- Apply silicone in drilled holes and caulk the escutcheon-to-wall joint.
Images and diagrams
- Step 1 shows tapping the escutcheon from the back to loosen it.
- Step 2 illustrates using a level to ensure the bar is plumb.
- Step 6 demonstrates aligning the 3 dimples on the escutcheon with the protrusions on the mounting plate.
Model compatibility
- Designed for concealed mounting.
- Requires wall studs or blocking for secure installation.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.