Expandable Curved Shower Rod Taymor 02-D9688

Quick guide from the manual

The Taymor 02-D9688 is an expandable curved shower rod designed to provide 25% more shower space. Before installation, ensure your tub width does not exceed 72 inches (182.8 cm). The installation requires precise measurements based on your tub width to determine the correct drilling distance from the front edge of the tub.

Tools required

• Measuring tape
• Pencil
• 3/16 inch (5 mm) drill bit
• Drill
• Hammer
• Phillips screwdriver

Installation steps

1. Measurements

Lay out all components on a soft surface. Measure 65 inches (165 cm) above the ledge of the tub on both sides. Use the reference guide below to determine the distance from the front edge of the tub to the drilling point.

2. Position top anchors

Drill a hole into the drywall or tile at the marked position using a 3/16 inch (5 mm) drill bit. Use a hammer to gently tap the anchor into the hole until it is flush with the wall.

3. Position bottom anchors

Align the top hole of the plastic support with the installed top anchor. Mark the bottom hole through the plastic support, ensuring it is perfectly straight. Drill the bottom hole and insert the anchor.

4. Install brackets

Place the left bracket over the plastic support, ensuring it points outwards from the tub. Secure it using the large screws and a Phillips screwdriver. Repeat this process for the right side.

5. Install rod

Insert the smaller rod into the larger rod. Position the rod ends over the brackets and secure them using the small screws.

Safety precautions

• Do not allow children to climb, swing, or hang on the curtain or the rod.
• The rod is not designed to support a person pulling or leaning against it.
• Clean the rod by wiping it with a damp cloth.