User Guide for Ecosmart 11A19060WRGBW01 Remote Controlled LED A19 Color Changing Smart Bulb Kit

Quick guide from the manual

This document provides instructions for the Ecosmart 11A19060WRGBW01 smart bulb kit. The bulb and remote are pre-paired at the factory. To begin, screw the bulb into a standard E26 socket, remove the plastic battery strip from the remote, and the system is ready for use.

Safety Information

• For indoor use only; do not expose to water.
• Not for use in totally enclosed or recessed fixtures.
• Do not use with standard dimmers or dimming controls.
• Maintain a minimum distance of 20 cm between the bulb and your body during operation.
• Turn off power before installation or removal.

Operation

The remote controls up to 20 bulbs. Use the buttons on the remote to manage your lighting:

• ON/OFF: Toggle the light power.
• Dimming: Adjust brightness from 3% to 100% (5 levels). Short presses change brightness incrementally; holding the button provides a smooth transition.
• Customize White Light: Adjust color temperature from 2700K to 6500K (5 options).
• Change Colors: Cycle through 6 colors (Red, Yellow, Green, Cyan, Blue, Magenta).

Pairing and Unpairing

If you need to pair a new bulb or re-pair an existing one:

1. Turn the bulb on and hold the remote within 2 inches of the bulb.
2. Press and hold the ON/OFF and Dimming buttons simultaneously for 3 seconds until the indicator light flashes.
3. The bulb will flash once to confirm successful linking.

To unpair, hold the ON/OFF and Customize White Light buttons for 3 seconds while within 2 inches of the bulb.

Factory Reset

To reset the bulb to factory settings, physically switch the wall power ON and OFF 6 times within 5 seconds. The bulb will flash twice to confirm the reset. To reset the remote, use the provided reset pin in the pinhole on the back of the remote for 3 seconds.

Maintenance

If the indicator light on the remote blinks twice rapidly, the battery is low. Replace the CR2450 3V battery by removing the battery cover with a screwdriver.

Troubleshooting

If the light does not respond, ensure the power is on and the circuit breaker is active. Verify the plastic battery strip has been removed from the remote and that the battery is installed correctly. If the remote has been linked to 20 bulbs, it has reached its limit and may require a factory reset.