Hilti AG 150-20SE Angle Grinder

Product Description

The Hilti AG 150-20SE is a high-performance, hand-held electric angle grinder engineered for professional use. It is versatile, capable of cutting and grinding both metal and mineral materials, as well as brushing, sanding, and hole cutting in tiles, all without the use of water. The tool features advanced safety and performance technologies, including 3D Active Torque Control (3DATC) to prevent sudden, unforeseen movements, constant-speed electronics for efficiency, and an integrated brake to reduce accessory stopping time.

Safety Information

Warning: Read all safety warnings, instructions, illustrations, and specifications provided with this power tool. Failure to follow all instructions may result in electric shock, fire, and/or serious injury. Always wear personal protective equipment, including eye protection, and ensure the work area is clean and well-lit. Never operate the tool without the appropriate guard. Always hold the product with both hands on the provided grips.

Operation

Before starting, ensure the side handle is securely fitted. The tool features 6 speed stages, adjustable via buttons, allowing for optimal performance based on the application. To operate, plug the tool into a power outlet, press the rear section of the on/off switch, slide it forward, and lock it. When cutting, maintain a moderate rate of advance and do not tilt the tool. For rough grinding, move the tool to and fro at a 5° to 30° angle of attack with moderate pressure.

Maintenance and Care

Regularly check all visible parts and controls for damage. Keep air vents clear at all times to prevent overheating. Clean the dust filter regularly and replace it if damaged. Do not use spray, steam pressure cleaning equipment, or running water for cleaning. If the tool is frequently used on conductive materials, have it checked by Hilti Service at regular intervals.

Troubleshooting

If the tool does not start, check the power supply and the supply cord. If the tool switches off and the speed control LEDs flash, it may be overloaded; release the switch and allow the tool to run under no load for 30 seconds. If 3DATC is activated, switch the tool off and on again. For persistent issues, contact Hilti Service.

Disposal

Most materials from which Hilti tools are manufactured can be recycled. Do not dispose of power tools, electronic equipment, or batteries as household waste.