Hygger HG-044 Aquarium Filter User Manual

Quick guide from the manual

The Hygger HG-044 is a 3-in-1 internal aquarium filter designed for oxygenation, filtration, and bacteria cultivation. Please note that an external air pump and air tubing are required for operation but are not included in the package.

Product diagram

The filter consists of the following components: black shell, air outlet, oxygenation pipe interface, suction cups, filter box, plastic clapboard, filter cotton, filter stone, and filter box cover.

Installation instructions

1. Separate the filter box from the black shell and open the filter box cover.
2. Place the filter cotton at the bottom of the filter box, secure it with the plastic partition board, and add the filter stones.
3. Close the filter box lid, reattach it to the black shell, and install the suction cups.
4. Connect your external air pump to the oxygenation pipe interface using tubing.
5. Place the filter at the bottom of the aquarium and secure it to the tank wall using the suction cups.
6. Turn on the air pump to begin operation. Ensure the filter is fully submerged and there is adequate water circulation.

Safety and maintenance

• Ensure the filter is always fully submerged during operation.
• Regularly clean the filter to remove internal debris.
• Do not use the device in flammable or corrosive liquids.
• Avoid using in water temperatures below 0°C or above 36°C.
• Always turn off the air pump before removing or replacing the filter.
• Keep out of reach of children.

Disposal

Do not dispose of this product with unsorted municipal waste. It must be recycled at an authorized facility for electrical and electronic appliances.

Contact information

For support, please contact Hygger via email at [email protected] or visit their website at www.hygger-online.com.