User Manual for HyperGear Power Brick 24,000mAh Laptop Power Bank

Quick guide from the manual

The HyperGear Power Brick is a high-capacity portable power bank designed for small electronics, including laptops. Before first use, ensure the unit is fully charged. The device features a 65W USB-C PD port, USB-A ports, and an AC outlet. Always use the included 20W USB-C PD wall charger to recharge the power bank to avoid damage and warranty voiding.

Product Overview

The device features the following components:

• Power Button for USB: Activates USB charging.
• USB-C Port: Used for both input (charging the bank) and output (charging devices).
• USB-A Ports: Standard ports for charging mobile devices.
• Power Level Indicator: Four LEDs showing remaining battery capacity.
• LED Flashlight: Built-in light.
• AC Power Button & Indicator: Controls the AC outlet.
• AC Power Outlet: Provides 120V AC power.
• AC Outlet Cover: Protects the outlet when not in use.

Charging the Power Bank

To charge the Power Brick, connect it via the USB-C port using the included 20W USB-C PD wall charger and cable. The blue LED lights will blink to indicate charging progress. When all four lights are solid, the unit is fully charged. A full charge takes approximately 2.5 to 3 hours. Do not use third-party chargers as they may damage the unit.

Using USB Ports

Connect your device to the USB-C or USB-A port using a compatible charging cable. Charging should start automatically. If it does not, press and hold the power button until the LED indicators light up. The device supports pass-through charging, allowing you to power USB devices while the power bank itself is being recharged.

Using the AC Outlet

To use the AC outlet:

1. Open the AC outlet cover.
2. Plug in your AC-powered device.
3. Press and hold the AC power button for 2-3 seconds to turn on the AC output. The indicator light will turn blue.
4. When finished, press and hold the AC power button for 2-3 seconds to turn off the AC output, then disconnect your device.

Note: If using the AC outlet, it is recommended to charge only one USB device at the same time.

LED Flashlight

To turn the LED flashlight on or off, double-press the power button.

Safety and Maintenance

• Do not connect live AC power to the power bank's AC outlet.
• Do not disassemble, modify, or repair the unit.
• Keep away from extreme temperatures (below 40°F or above 90°F).
• Do not expose to liquids, rain, or snow.
• Charge the unit at least once every 3 months if not in use.
• If the device emits an odor, becomes deformed, or shows abnormal phenomena, discontinue use immediately.
• Keep fingers clear of the AC outlet prongs.