Tools / Power Tools
User Manual for Ridgid R87064 18V Subcompact Brushless 1/4 Sheet Sander
Comprehensive operator's manual for the Ridgid R87064 18V Subcompact Brushless 1/4 Sheet Sander. This guide provides essential instructions on safety, battery installation, sandpaper selection, dust collection, vacuum connection, and...
Table of contents
Quick Guide
This manual provides instructions for the Ridgid 18V Subcompact Brushless 1/4 Sheet Sander. Always wear eye protection with side shields and a dust mask when operating. Ensure the battery is removed before making adjustments, changing sandpaper, or performing maintenance.
Product Specifications
- Size of Paper: 1/4 Sheet
- Motion: Orbital Action
- Orbit Diameter: 1/16 in.
- No Load Speed: 7,000 - 12,000 OPM
Assembly and Setup
Installing/Removing Battery Pack
To install, insert the battery pack and ensure the latches on each side snap into place. To remove, depress the latches on each side of the battery pack.
Installing Standard Sandpaper
- Remove the battery pack.
- Release the rear paper clamp by lifting the lever (marked 2).
- Push and hold the button (marked 1) on the front to open the front paper clamp.
- Insert the sandpaper into the front clamp, wrap it around the cushion, and secure the loose end under the rear clamp.
- Push down the lever to lock the rear clamp.
Paper Punch
Use the supplied paper punch template to align and punch holes in the sandpaper to match the sanding pad. Align the sanding pad over the punch and push down.
Operation
Turning the Sander On/Off
Insert the battery pack and push the ON/OFF button to start. Push again to stop. The tool is always in the OFF mode when the battery is not installed.
Variable Speed Dial
Adjust the sanding speed using the dial, ranging from 1 (lowest) to 6 (highest).
Dust Collection
Dust Bag: Align the grooves on the dust bag with the notches on the sander dust exhaust. Turn clockwise to lock. Turn counterclockwise to unlock and remove for emptying.
Vacuum Connection: The sander can connect to 1-1/4 in. or 1-7/8 in. vacuum hoses. Remove the dust bag, then attach the vacuum hose to the dust exhaust port.
Maintenance
Avoid using solvents when cleaning plastic parts. Use clean cloths to remove dirt, dust, oil, and grease. For service or parts, contact Ridgid customer service at 1-866-539-1710 or visit powertools.ridgid.com.
Official resources from the manual
Manufacturer information
RIDGID
Practical help
Common problems
Sander overheats during extended use
Turn off the tool, remove the battery and sandpaper, empty the dust bag, and run the tool without a load to cool the motor.
Sander not removing material effectively
Do not force the tool; the weight of the unit provides adequate pressure. Excessive pressure slows the motor and reduces speed.
Dust bag not locking
Ensure the grooves on the dust bag are aligned with the notches on the sander dust exhaust before turning clockwise.
Before use
- Ensure the battery pack is charged.
- Wear eye protection with side shields (ANSI Z87.1).
- Wear a dust mask if the operation is dusty.
- Check that sandpaper is correctly installed and tight.
- Secure the workpiece to prevent movement.
Specs in practice
- 7,000 - 12,000 OPM
- The variable speed range in Orbits Per Minute.
Model compatibility
- Compatible with 1-1/4 in. and 1-7/8 in. vacuum hoses.
- Not recommended for use with 8Ah or higher battery packs.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.