Rockville ROCKFORCE W2 192-Channel Wireless DMX Lighting Controller User Manual

Quick guide from the manual

The ROCKFORCE W2 is a 192-channel wireless DMX lighting controller. Before first use, ensure the unit is placed on a stable, level surface in a well-ventilated area. Avoid moisture to prevent electric shock. For support, visit rockvillesupport.com/rockforce-w2 or call 1-646-758-0144.

Wireless Transmitter Function

The controller features seven wireless groups, each represented by a color. To connect:

• Power on the controller and your wireless receiver(s).
• Press the Wireless ID button on the controller to enter pairing mode (LED will flash red).
• Use the button under the LED to select a color. Match the color on your receiver(s) to the transmitter.
• Once connected, the transmitter LED will flash red and the receiver LED will flash green.

DMX Connections

The unit uses 3-pin XLR connectors. If using 5-pin fixtures, use a 3-pin to 5-pin adapter. For long chains, terminate the last fixture with a 120 Ohm resistor across the DATA- and DATA+ wires to prevent signal noise.

Programming Scenes

To record a scene:

1. Press and hold the PROGRAM button for 3 seconds to enter program mode.
2. Select a fixture using the SCANNER buttons.
3. Adjust channel faders to set the desired output.
4. Press ADD to record the step.
5. Select a bank (UP/DOWN) and a SCENE button (1-8) to save.
6. Press and hold PROGRAM for 3 seconds to exit.

Programming Chases

A chase consists of multiple recorded scenes:

1. Select a chase (1-6) using the CHASE button.
2. Select the bank and scene you wish to add.
3. Press ADD to record the step.
4. Repeat as needed (up to 240 steps).
5. Exit program mode by holding PROGRAM for 3 seconds.

Operating Modes

The controller supports Manual, Auto-Run, and Music-Sync modes. Use the AUTO/DEL button to toggle Auto-Run, or the MUSIC/BANK COPY button to trigger scenes/chases via the internal microphone.