User Manual for RØDE Wireless Micro Microphone System

Quick Start Guide

Follow these steps to set up your RØDE Wireless Micro system for the first time:

1. Prepare the Transmitters: Remove both transmitters from the charging case. Remove the stickers covering their charging pins, then return them to the case.
2. Power On: Remove both transmitters from the case again. Their LEDs will begin to flash, indicating they are powered on.
3. Connect and Pair: Remove the receiver from the case and connect it directly to your phone. The receiver's LEDs will flash to indicate it is pairing, and will remain solid once successfully paired.
4. Record: You are now ready to start recording.

Software and Firmware

To adjust settings and update your device firmware, download the RØDE Central application. You can find the download link at rode.com/apps/rode-central.

Important Safety Information

• Read and understand all instructions and the safety guide completely before using the product.
• Ensure the instruction manual and safety guide are accessible to all users.
• Use this product only with authorized RØDE accessories.
• Do not open the product housing, as this will void the warranty.
• Refer all service and repairs to RØDE-approved service personnel.
• Keep the product away from liquids and electrically conductive objects that are not necessary for operation.
• Do not use solvents or corrosive cleaning agents to clean the product.
• Do not adjust the product controls in environments that require your full attention, such as while driving or operating machinery.
• This appliance contains a battery that should only be replaced by a skilled person.

Technical Specifications

Power Input: 5VDC, 0.5A

Regulatory Compliance

This device complies with part 15 of the FCC rules. Operation is subject to the conditions that the device may not cause harmful interference and must accept any interference received. The device has been tested and found to comply with the limits for a Class B digital device. For EU compliance, the device is in compliance with Directive 2014/53/EU.