User Manual for VS Sassoon Blowout Bestie Hot Air Brush VSLE114A
Quick guide for the VS Sassoon Blowout Bestie Hot Air Brush (VSLE114A). Learn how to use, style, clean, and maintain your hot air brush for optimal results.
Table of contents
Quick Guide
The VS Sassoon Blowout Bestie is a hot air brush designed to dry, shape, and add volume to hair. Important Safety Note: Never use this appliance near water (bathtubs, showers, basins). Always unplug after use. If the device falls into water, unplug it immediately and do not reach into the water. Do not use on heavily bleached or chemically treated hair without using the low heat setting.
Product Overview
The device features a 55mm oval-shaped barrel with detangling bristles, 700 watts of styling power, and a swivel power cord. It includes two heat settings plus a cool setting to set your style.

Operating Instructions
Preparation: Wash, condition, and towel dry your hair. Ensure it is slightly damp, combed through, and tangle-free. Remove all packaging and the plastic cover from the plug.
Styling Process:
- Divide hair into 3cm - 5cm wide sections.
- Twist the switch to the appropriate heat setting: High (II) for medium to thick hair, Low (I) for delicate/fine/bleached hair, or Cool for setting the style.
- Wrap & Release: Place the brush at the ends, roll up to the roots, wait 10-20 seconds, then slowly wind downward.
- Blow-out Boost: Place the brush near the root, brush away from the head while rotating for volume. Hold for about 10 seconds per section.
- For longer-lasting results, use the cool setting for a few seconds after heating each section.
Styling Tips
- Straight: Divide hair into sections and slowly glide the brush from top to bottom, curling under to smooth the cuticle.
- Volume: Loosely wrap sections around the brush. For more bounce, wrap tightly and hold longer.
Cleaning & Maintenance
Blocked air intake vents cause overheating. The rear filter should be checked and cleaned regularly using a soft brush to remove hair and debris. If the device overheats and shuts off, unplug it and allow it to cool for 15 minutes before restarting.
Warranty
This product includes a 2-year limited warranty. To make a claim, you must present proof of purchase (receipt or invoice). Contact Conair Customer Service in Australia (1800 650 263) or New Zealand (0800 266 247) for assistance.
Practical help
Common problems
The automatic safety device has triggered due to overheating. Unplug the cord, clean the air vents, and allow the styler to cool for 15 minutes before restarting.
Do not use the appliance. The cord must be replaced by the manufacturer or a qualified service agent to avoid hazards.
Ensure you are using the correct heat setting. Use the low heat setting for bleached or chemically treated hair. Do not hold the brush too close to the scalp or skin.
Before use
- Remove all packaging and point of sale labels.
- Remove the plastic cover from the plug.
- Ensure hair is slightly damp, combed through, and tangle-free.
- Verify that the voltage marked on the appliance matches your local power supply.
- Ensure the switch is set to the off (0) position before plugging in.
Specs in practice
- 55mm Oval Barrel
- Designed for smoothing and adding volume to hair.
- Cool Setting
- Used to set the style after heating the hair section.
Images and diagrams
- 1: Power switch (Heat settings)
- 3: 55mm oval-shaped barrel
- 5: Easy hold cool tip
- 6: Swivel power cord
- 7: Fixed rear filter
Model compatibility
- Not intended for commercial use.
- Do not use with extension cords.
- Use only attachments supplied by Conair Australia Pty Ltd.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.