Hvac / Air Conditioners
Remote Controller Owner's Manual for ACiQ Wall-Mounted Air Handler
Quick guide for the ACiQ remote controller, covering battery installation, basic operation modes, timer settings, advanced functions like Turbo, ECO/GEAR, and troubleshooting tips.
Table of contents
Quick guide from the manual
This manual provides instructions for operating the ACiQ remote controller (models RG10L5/RG10L6). Ensure the unit is plugged in and powered before use. The remote must be used within 8 meters of the indoor unit. If the indoor unit lacks a specific feature, the corresponding button on the remote will have no effect.
Handling the Remote Controller
To insert or replace batteries, slide the back cover downward, insert two R03/LR03 batteries matching the (+) and (-) symbols, and slide the cover back. Do not mix old and new batteries. Remove batteries if the remote will not be used for more than 2 months.
Basic Functions
- AUTO Mode: The unit automatically selects COOL, FAN, or HEAT based on the set temperature. Fan speed cannot be adjusted.
- COOL/HEAT Mode: Set the desired temperature and fan speed.
- DRY Mode: Fan speed is automatically controlled.
- FAN Mode: Temperature cannot be set.
Setting the TIMER
TIMER ON/OFF: Press the TIMER button to initiate the sequence, use the Temp up/down buttons to set the desired time (30-minute increments up to 10 hours, 1-hour increments thereafter), and point the remote at the unit to activate. Cancel by setting the timer to 0.0h.
Advanced Functions
- Swing: Press to start/stop horizontal louver movement. Hold for 2 seconds for vertical louver auto swing.
- Turbo: Enables the unit to reach the set temperature in the shortest time.
- ECO/GEAR: Enters energy-efficient modes (ECO, GEAR 75%, GEAR 50%).
- LED: Turns the indoor unit's display and buzzer on/off.
- SET Function: Allows selection of features like Breeze Away, Active Clean, Fresh/UV-C, Sleep, and Follow Me.
Safety and Maintenance
Keep the remote away from direct sunlight and obstructions like curtains. The unit will beep when a signal is received. For technical support or compliance information, contact 1HVAC Energy, LLC at 1-877-909-2247.
Manufacturer information
ACiQ
Practical help
Common problems
Remote signal not received
Ensure you are within 8 meters of the unit and that there are no obstructions like curtains or direct sunlight interfering with the infrared receiver.
Function button has no effect
The indoor unit may not support that specific function. The remote is universal for several models.
Insufficient cooling/heating
Check if ECO or Silence mode is active, as these may limit compressor frequency and capacity.
Before use
- Ensure the air conditioner is plugged in and has power.
- Install two R03/LR03 batteries in the remote.
- Verify the remote is within 8 meters of the indoor unit.
- Check that no curtains or objects block the infrared signal.
Specs in practice
- Signal Receiving Range
- The remote must be within 8 meters of the indoor unit to function.
- Temperature Range
- Adjustable between 16°C and 30°C (60°F - 86°F).
- Humidity Range
- Adjustable between 35% and 85% during Dry operation.
Images and diagrams
- The remote features a central OK button for confirmation, surrounded by navigation arrows for temperature and settings.
- The display shows the current mode (AUTO, COOL, DRY, HEAT, FAN), set temperature, and active features like ECO or Turbo.
Model compatibility
- Compatible with ACiQ models: 06W-HH-MD, 09W-HH-MD, 12W-HH-MD, 18W-HH-MD, 24W-HH-MD.
- HEAT mode is not supported by cooling-only appliances.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.