Tools / Drills
Bosch GSR 18V-55 Professional Cordless Drill Instruction Manual
Quick guide for the Bosch GSR 18V-55 Professional Cordless Drill, covering battery installation, tool changing, operating modes, and safety instructions.
Table of contents
Quick guide from the manual
This document provides essential information for the safe and efficient operation of the Bosch GSR 18V-55 Professional Cordless Drill. Always read the full safety instructions before use.
Device Description
The tool is designed for driving and loosening screws and for drilling in wood, metal, ceramic, and plastic. The GSB model is also designed for impact drilling in brick, masonry, and stone.
Assembly
Remove the battery before any work on the power tool (e.g., maintenance, tool change, etc.) and for transport/storage to prevent accidental activation.
Charging the Battery
Use only the chargers listed in the technical data. The battery is supplied partially charged; fully charge it before the first use.
Tool Change
The drill spindle is locked when the on/off switch is not pressed, allowing for quick and easy tool changes. Open the keyless chuck by turning it, insert the tool, and tighten the chuck firmly by hand.
Operation
Inserting the battery: Push the charged battery into the base of the tool from the front until it locks securely.
Setting the rotational direction: Use the rotational direction switch to change the direction. Do not operate while the on/off switch is pressed.
Operating modes: Set the torque/mode presetting ring to the desired symbol (Drilling, Screwdriving, or Impact Drilling for GSB models).
Switching on/off: Press and hold the on/off switch to start. Release to stop.
Adjusting speed: Speed is infinitely variable depending on how far the on/off switch is pressed.
Maintenance and Service
Keep the power tool and ventilation slots clean for safe and efficient operation. For repairs or spare parts, contact your local Bosch service center.
Manufacturer information
Bosch
Practical help
Common problems
Tool does not start
Check if the battery is charged and correctly inserted. If no LEDs light up on the battery indicator, the battery may be defective.
Tool stops during operation
The temperature-dependent overload protection may have triggered. Allow the tool to cool down until it reaches the permitted operating temperature.
Before use
- Ensure the battery is fully charged.
- Check that the correct tool bit is inserted and tightened in the chuck.
- Verify the rotational direction switch is set correctly.
- Ensure the operating mode (drilling/screwdriving) is correctly selected.
- Check that the gear selector is fully engaged.
Specs in practice
- Rated voltage
- 18V, indicates the battery system compatibility.
- No-load speed
- 0-460 rpm (1st gear) / 0-1800 rpm (2nd gear), determines the speed range for different tasks.
Images and diagrams
- Figure A: Shows the process of opening the keyless chuck, inserting a bit, and tightening the chuck.
- Figure B: Illustrates the rotational direction switch settings for right (drilling/screwdriving) and left (loosening) rotation.
Model compatibility
- Compatible with all Bosch Professional 18V batteries (GBA 18V and ProCORE18V series).
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.