Tools / Drills
Bosch GSR 18V-65 / GSB 18V-65 Cordless Drill Driver User Manual
Quick guide for the Bosch GSR 18V-65 and GSB 18V-65 cordless drill drivers. Includes setup, operation, safety instructions, and troubleshooting.
Table of contents
Quick guide from the manual
This document provides essential information for the safe and efficient use of the Bosch GSR 18V-65 and GSB 18V-65 cordless drill drivers. Always read the full safety instructions before use.
Device description
The tool is designed for driving and loosening screws and for drilling in wood, metal, ceramic, and plastic. The GSB model is also designed for impact drilling in brick, masonry, and stone.
Assembly
Tool change: The drill spindle is locked when the on/off switch is not pressed. Open the keyless chuck by turning it in the direction of rotation until the tool can be inserted. Tighten the chuck firmly by hand until a click is heard.
Operation
Starting operation: Press and hold the on/off switch to start. The worklight illuminates the work area when the switch is pressed. Release the switch to stop.
Setting rotational direction: Use the rotational direction switch to change the direction. Do not change while the on/off switch is pressed.
Operating modes: Use the torque presetting ring (GSR) or operating mode presetting ring (GSB) to select between drilling, screwdriving, and impact drilling (GSB only).
KickBack Control: This feature provides better control and user protection. If the tool suddenly rotates around the drill axis, it will switch off automatically. The worklight will flash and the KickBack Control button will light up red.
Maintenance and cleaning
Always remove the battery before performing any work on the tool. Keep the tool and ventilation slots clean for safe operation.
Manufacturer information
Bosch
Practical help
Common problems
KickBack Control triggered (red light on button)
Release the on/off switch, then press it again to restart.
Tool does not start
Check if the battery is charged and properly inserted. If KickBack Control is faulty, the tool cannot be switched on; contact a qualified repair person.
Before use
- Ensure the battery is fully charged.
- Check that the correct tool bit is inserted and the chuck is tightened.
- Set the correct rotational direction.
- Select the appropriate operating mode (drilling, screwdriving, or impact drilling).
- Ensure the gear selector is fully engaged.
Specs in practice
- Rated voltage
- 18V, indicates the battery system compatibility.
- No-load speed
- 0-550 min-1 (1st gear) / 0-2100 min-1 (2nd gear).
Model compatibility
- Compatible with Bosch 18V GBA and ProCORE18V batteries.
- Use only chargers listed in the technical data.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.