findmanualpdf.com

Instruction Manual for Dimplex 10/14 E and EL Dehumidifier

Quick guide for the Dimplex 10/14 E and EL dehumidifier, covering setup, operation, maintenance, and troubleshooting for safe and efficient use.

Table of contents

Manual images

Jump to the section

Quick guide from the manual

This document provides essential operating instructions for the Dimplex 10/14 E and EL dehumidifier models. Before first use, ensure the unit has settled in an upright position for 12 hours. The device is intended for indoor residential use only and must not be used in bathrooms or near water sources. Always maintain a 50cm clearance around the unit for proper airflow.

Safety and Refrigerant R290

This appliance contains R290 refrigerant gas. It must be installed and stored in a room with a minimum floor area of 4m2 for 10L models and 7m2 for 14L models. Do not pierce or burn the cooling circuit. Ensure the unit is placed on a firm, flat surface and kept away from heat sources or open flames.

First time operation

Control panel layout and button identification.
Control panel layout and button identification.
  1. Ensure the unit has settled for 12 hours after transport.
  2. Remove the carbon filter from its packaging and install it between the anti-dust filter and the air inlet.
  3. Plug the unit into a properly installed, accessible mains socket.
  4. Press the ON/OFF button to start.
  5. Use the humidity setting button to select your desired target humidity (40%, 50%, 60%, 70%) or continuous mode (CONT).
  6. Use the TIMER button to set operating duration (up to 15 hours).

Drainage

When the water tank is full, the compressor stops automatically. To empty, pull the tank out squarely. For continuous drainage, connect an 11mm inner diameter tube to the drain spout inside the tank compartment. Ensure the tube is positioned at a lower height than the outlet to allow gravity drainage.

Connecting the continuous drainage tube.
Connecting the continuous drainage tube.

Maintenance

Always unplug the unit before cleaning. Wipe the body with a soft, damp cloth. The plastic anti-dust filter should be washed every 2 weeks. The active carbon filter is not washable; remove it and place it in sunlight for a few hours every 3-6 months to recharge its properties.

Removing and cleaning the filters.
Removing and cleaning the filters.

Troubleshooting

If the unit does not operate, check the power connection, room temperature (must be between 5°C and 32°C), and ensure the water tank is correctly seated. If the power light flashes, the unit may be in defrost mode. Error codes 1H, 2H, 4H, or 8H indicate a malfunction; please contact customer service.

Manufacturer information

Dimplex

Brand profile

Practical help

Common problems

Unit does not operate

Check power supply, ensure room temperature is between 5°C and 32°C, and verify the water tank is correctly inserted and not full.

Unit is noisy

Ensure the unit is placed on a firm, level surface.

Water leakage

Check that the unit is level and the water tank is fitted correctly and undamaged.

Error codes 1H, 2H, 4H, 8H

These indicate sensor or connection malfunctions. Disconnect from mains and contact customer service.

Before use

  • Ensure the unit has stood upright for 12 hours after transport.
  • Install the carbon filter between the anti-dust filter and air inlet.
  • Check that the room size meets the minimum requirement (4m2 for 10L, 7m2 for 14L).
  • Ensure a 50cm clearance around the unit.
  • Verify the mains voltage matches the rating label.

Specs in practice

Working range
The ambient temperature range (5-32°C) in which the dehumidifier operates effectively.
R290 Refrigerant
Flammable refrigerant gas; requires careful handling and specific room size requirements.
Continuous mode (CONT)
The unit runs regardless of the ambient humidity level.

Images and diagrams

  • The control panel features buttons for power, humidity settings, and timer, with corresponding LED indicators.
  • The rear of the unit houses the air inlet, filters, and the continuous drainage spout.
  • The Comfort Humidity Light (14EL only) provides visual feedback: Blue (>70%), Green (50-70%), Red (<50%).

Model compatibility

  • Not for use in bathrooms, near showers, or swimming pools.
  • Do not use in small enclosed spaces, commercial, or industrial applications.
  • Do not use extension leads or multiple socket outlets.

Manual page author

Michael Turner

Technical manual editor

Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.