Home Appliances / Small Kitchen Appliances
Eureka Forbes Aeroguard Auto 10X Air Purifier
Quick guide for the Eureka Forbes Aeroguard Auto 10X air purifier. Learn how to operate, clean, and maintain your device, including filter replacement and safety instructions.
Table of contents
Quick guide from the manual
The Aeroguard Auto 10X is designed for air purification. To operate the device, use the power/level button located on the unit. A long press turns the device on or off, while a single touch toggles between Speed 1 and Speed 2. If power is restored after a shutdown, the unit will resume in its previous operation state.
Safety precautions
- Use only the specified adapter (DC5V, 1A). Do not use a damaged adapter or power cord.
- Do not insert foreign objects into the air inlet or outlet.
- Do not use the product in humid areas or near flammable gases/combustible materials.
- Do not immerse the product in water.
- Do not open the cover while the product is in operation.
- If the product is damaged or immersed in water, unplug it immediately.
Names of parts
The unit consists of the following main components:
- Power/Level Button
- Indicator
- Upper Cover
- Pre-filter
- HEPA Filter
- TiO2 Ceramic Filter
- Back Cover
- AC/DC Adapter
How to operate
Ensure there are no obstacles blocking the air inlet or outlet. The device is operated via the Power/Level button:
- Power On/Off: Long press the button.
- Speed Control: Single touch to switch between Speed 1 and Speed 2.
Cleaning and maintenance
Regular maintenance ensures optimal performance. Always disconnect the power cord before cleaning.
- General Cleaning: Wipe the product with a soft, dry cloth. Never spray water directly on the unit or use detergents containing organic solvents, bleach, chlorine, or abrasives.
- Pre-filter: Periodically clean the dust from the pre-filter.
- TiO2 Ceramic Filter: This filter can be cleaned by immersing it in boiling water for 20 to 30 minutes. Dry it completely using a paper towel before re-inserting.
Filter replacement
The HEPA filter is a consumable part and should be replaced periodically. The recommended replacement cycle is approximately 6 months, depending on the environment. Purchase the HEPA filter separately and replace it by removing the back cover and accessing the filter housing.
Practical help
Common problems
Product does not turn on
Check if the adapter is properly connected and not damaged. Ensure the power source is active.
Product was immersed in water
Immediately unplug the power cord and do not use the product.
Dust accumulation
Periodically clean the pre-filter to maintain airflow.
Before use
- Ensure the specified adapter (DC5V, 1A) is used.
- Check that the power cord and adapter are not damaged.
- Verify that there are no obstacles blocking the air inlet or outlet.
- Ensure the unit is used with all filters installed.
- Confirm the product is not placed near flammable gases or combustible materials.
Specs in practice
- HEPA Filter Cycle
- Recommended replacement every 6 months.
- TiO2 Filter Cleaning
- Boil for 20-30 minutes every 6 months.
Model compatibility
- Use only the specified adapter provided or compatible with DC5V, 1A specifications.
- HEPA filter is a consumable item and must be purchased separately.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.