User Manual for Homcom 160cm Inflatable Santa Claus on Snowmobile

Quick guide from the manual

This inflatable decoration is designed for seasonal use. To set it up, place the unit in a clean, open area, plug the adapter into an electrical outlet, ensure the zipper on the back is closed, and secure the figure to the ground using the provided metal stakes. If the unit does not inflate properly, check the zippers and ensure the fan intake is not blocked by debris or snow.

Safety Instructions

• This is a seasonal decoration and is not intended for permanent installation or year-round use. It is recommended not to use for more than 90 consecutive days.
• Do not attempt to inflate during unusually strong winds.
• This is an electrical product, not a toy. Keep out of reach of children.
• Protect the electric fan and power cord from water to reduce the risk of electric shock.
• Do not expose the product to sharp items.
• If the temperature is below 5°F (-15°C), the motor may temporarily stop running. It will begin functioning again at higher temperatures.

Setup and Use

1. Remove contents from packaging.
2. Place the inflatable in a clean, open area, free from obstruction or other debris.
3. Roll out the fabric and lay out the contents.
4. Plug the adaptor into the appropriate electric outlet.
5. Turn the unit upright. Ensure the air intake of the fan is clear of fabric and free of obstruction.
6. Ensure the zipper is closed so the figure can fully inflate.
7. To secure the inflatable from winds, insert a metal stake into the ground through each of the holes in the lower tabs of the inflatable figure.
8. To deflate, simply unplug from the outlet and open the zipper on the back of the inflatable. Do not unplug by pulling on the cord.

Care and Maintenance

Periodically check to ensure there are no holes or tears in the inflatable figure. If you find any tears in the fabric, you can repair them with a needle and regular thread. No special thread is necessary.

• Only use mild detergent with cold water and a damp soft cloth to wipe clean the figure.
• Periodically unplug the product from the electrical outlet and allow the transformer and fan to cool to avoid overheating and product damage.
• Neatly fold and store the product in a cool, dry location that is away from sunlight or heat sources.
• Unplug, roll up, and store in the original package or a similar size box.
• Do not wipe clean the motor.

Troubleshooting

If the item will not fully inflate, ensure the zippers on the back of each inflatable figure are closed, inspect the fabric for tears and holes, and make sure the fan is not obstructed by any debris or snow. If the fan does not operate, ensure it is plugged into a working outlet (for indoors, a standard AC outlet; for outdoors, a GFCI outlet) and allow it to cool completely if it has overheated.