General / Other Manuals
One Control Prussian Blue Reverb Revival 15th Anniversary User Guide
Quick start guide for the One Control Prussian Blue Reverb Revival 15th Anniversary pedal, covering controls, power requirements, technical specifications, and usage tips for guitar and bass.
Table of contents
Quick guide from the manual
The Prussian Blue Reverb Revival 15th Anniversary is a limited edition pedal designed to provide a natural, studio-quality reverb sound. It features a 24-bit digital chip with a custom program by BJF, while maintaining an analog dry-through signal path. It is suitable for electric guitar, bass, and acoustic instruments.
Controls and Usage
- INPUT: Connect your instrument cable here.
- OUTPUT: Connect to your amplifier.
- LEVEL: Adjusts the overall output volume of the effect.
- DECAY: Controls the length of the reverb tail (from 2ms to 2s).
- TONE: Adjusts the high-frequency content of the reverb effect only; does not affect the dry signal.
- KILL DRY (Internal): Mutes the dry signal, useful for parallel effects loops or creating slow-volume effects.
- FOOT SWITCH: Toggles the effect on/off (True Bypass).
Power Supply
The pedal operates on 8-12V DC (center negative). One Control EPA-2000 is recommended. To use a 9V battery, remove the four screws on the back plate and insert a 006P 9V battery.
Important Operational Notes
- Upon initial power-up, the internal digital chip requires a few seconds to stabilize. It is recommended to wait a few seconds after connecting power before engaging the effect.
- Due to the design, the pedal may amplify small noises from cables when engaged. For complete silence, bypass the effect.
Technical Specifications
- Input Impedance: 500K
- Output Impedance: 2K
- Current Draw: 32mA
- S/N Ratio: -96dBm
- Dimensions: 39W x 100D x 31H mm (excluding protrusions)
- Weight: Approx. 160g (200g with battery)
Practical help
Common problems
Unstable sound immediately after power-up
The internal digital chip requires a few seconds to stabilize. Wait a few seconds after connecting power before engaging the effect.
Small noises heard even when instrument is muted
The pedal may amplify noise from cables when engaged. Bypass the effect for complete silence.
Before use
- Ensure you are using an 8-12V DC center-negative power supply.
- If using a battery, ensure it is a 006P 9V type.
- Check that your cables are securely connected to INPUT and OUTPUT jacks.
- Wait a few seconds after powering on before engaging the effect to allow the chip to stabilize.
Model compatibility
- Suitable for electric guitar, electric bass, and acoustic instruments.
- True Bypass switching when the effect is off.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.