Furniture / Storage Cabinets
User Manual for Sealey PTB181510 Topchest and PTB183015 Rollcab
Quick guide for the Sealey PTB181510 Topchest and PTB183015 Rollcab. Includes assembly instructions, drawer operation, maintenance, and safety guidelines.
Table of contents
Manual images
Jump to the sectionQuick guide from the manual
This manual provides instructions for the assembly and operation of the Sealey PTB181510 Topchest and PTB183015 Rollcab. Important: These cabinets are heavy; two people are required to complete the assembly safely. Always use the units on level, solid ground, preferably concrete.
Assembly
Roll Cab Handle Installation
Position the handle over the holes on the roll cab. Attach using the M6 x 12mm hex bolts and tighten securely.
Castor Installation
- Lay the roll cab on its back carefully, using a soft mat to protect the surface.
- Position the two rigid wheels in the center of the roll cab.
- Insert M8 x 20mm hex bolts through washers and brackets into the base; tighten securely.
- Repeat for the two swivel castors at the outer ends.
- Stand the roll cab upright carefully.
Roll Cab and Top Chest Connection
- Remove the worktop from the roll cab.
- Place the top chest onto the roll cab.
- Snap the connectors into the square holes on the back of the top chest.
- Fasten the connectors with the provided screws.
Operation
Lift Latch Drawers
- To open: Lift the drawer front while pulling it out.
- To close: Shut the drawer firmly until the latch engages.
- Troubleshooting: If the drawer does not latch, the hook may be misaligned. Bend the hook gently until it is parallel to the drawer edge.
Removing and Replacing Drawers
- To remove: Pull the drawer out almost fully. Locate the black locking levers. Lift one lever up and push the other lever down. Hold both in this position to pull the drawer out.
- To replace: Extend the runners from the cabinet. Engage the slides on either side of the drawer into the runners. Push the drawer closed squarely until it engages the locking levers.
Maintenance
- Lubrication: Lubricate drawer slides sparingly every six months.
- Cleaning: Clean metalwork periodically with warm water and a mild detergent.
- Finish: Car wax may be used to restore shine. Stubborn grease can be removed with a non-abrasive cleaner.
Manufacturer information
Sealey Group
Practical help
Common problems
Drawer does not latch
The hook may be misaligned or binding. Bend the hook gently until it is parallel to the drawer edge and engages when closed.
Difficulty removing drawers
Ensure you are lifting one locking lever up and pushing the other down simultaneously while pulling the drawer out.
Before use
- Ensure two people are available for assembly due to the weight of the cabinets.
- Prepare a soft mat on the floor to protect the cabinet finish during castor installation.
- Verify the work area is clean, uncluttered, and well-lit.
- Ensure the floor surface is level and solid (preferably concrete).
Images and diagrams
- Fig 1: Handle installation using M6 bolts.
- Fig 2: Castor installation on the base of the roll cab.
- Fig 3: Connecting the top chest to the roll cab using provided connectors.
- Fig 4: Operating the Lift & Latch mechanism.
- Fig 5 & 6: Using the locking levers to remove or replace drawers.
Model compatibility
- The PTB181510 Topchest is designed to be used with the PTB183015 Rollcab.
- Both units can also be used as standalone units.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.