Power / Batteries Chargers
Behringer PB1000/PB600 Pedal Board User Guide
Quick guide for the Behringer PB1000 and PB600 pedal boards, covering connection procedures, power supply setup, and technical specifications.
Table of contents
Quick guide from the manual
The Behringer PB1000 and PB600 are lightweight pedal boards designed to transport and power your effects pedals. The PB1000 accommodates up to 12 pedals, while the PB600 holds up to 6. Both units feature an integrated 1.7 A power supply and include necessary cabling for your stompbox collection.
Connections
Follow these steps to connect your equipment:
- INPUT: Connect your instrument cable here using a high-quality cable.
- TO EFFECTS: Sends the signal from your instrument to your effects pedals.
- FROM EFFECTS: Connect the stereo signal from your effects pedals here.
- OUTPUT TO AMP: Sends the final signal to your amplifier(s).
- 9 V: Connect the included 9 V power supply here.
- DC OUT: Use the included daisy-chain cable to power all your effects pedals from this connector.
Safety Instructions
- Do not use the device near water.
- Do not install near heat sources.
- Use only authorized attachments and accessories.
- Do not attempt to service the product yourself. Contact qualified service personnel for repairs, especially if the power cord or plug is damaged.
Application Example
The pedal board acts as a central hub. Connect your guitar to the INPUT, route the signal through your pedal chain via TO EFFECTS and FROM EFFECTS, and send the final output to your amplifier via OUTPUT TO AMP. Power is supplied to the board via the 9 V input and distributed to individual pedals using the daisy-chain cable connected to the DC OUT port.
Technical Specifications
Both models include a 9 V, 1.7 A switching adaptor. The power connector is a 2 mm DC jack, center negative. The power consumption is 2 mA. The operating ambient temperature is up to 45°C.
Manufacturer information
Behringer
Practical help
Common problems
No power to pedals
Ensure the 9 V power supply is connected to the 9 V input and the daisy-chain cable is properly connected to the DC OUT port and all pedals.
Signal issues or noise
Ensure you are using high-quality instrument cables and that all connections (INPUT, TO EFFECTS, FROM EFFECTS, OUTPUT TO AMP) are secure.
Before use
- Verify the power supply voltage matches your region (120 V or 230 V versions available).
- Ensure you have enough patch cables for your pedal configuration.
- Check that the power cord and plug are not damaged.
- Confirm the pedals are placed on a stable surface.
Specs in practice
- Power Supply
- 9 V, 1.7 A switching adaptor included with the board.
- Power Connector
- 2 mm DC jack, center negative polarity.
Model compatibility
- PB1000 supports up to 12 pedals.
- PB600 supports up to 6 pedals.
- Ensure pedals are compatible with 9 V DC center-negative power.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.