Commercial Electric Foot Pedal Switch 804914 User Guide

Quick guide from the manual

This guide provides instructions for installing the Commercial Electric Foot Pedal Switch (Model 804914). This switch is designed for use with 18AWG SPT-1 or SPT-2 lamp cords.

Installation and Wiring

1. Turn off the power supply before starting any installation work.
2. Separate the wires on the lamp cord by making a 2-inch-long slit between the two wires at the location where the switch will be installed.
3. Cut only the non-ribbed wire at the center of the slit.
4. Remove the four screws from the switch base to open the housing. The spring and button will come loose during this process.
5. Insert the ends of the non-ribbed wire into the small holes on either side of the preassembled switch inside the base. Keep the ribbed wire loose until the non-ribbed wires are connected.
6. Locate the marking labeled N inside the base and route the ribbed wire into the track on that side. Ensure the wire is pressed down completely so it remains under the tabs.

Reassembly

Place the spring and button in order over the switch. Squeeze the top and base together completely and tighten all four screws to secure the housing.

Troubleshooting

If you need to remove a wire after it has been inserted, locate the small hole on the end of the switch corresponding to the wire. Insert a slotted screwdriver into the hole to release the wire, then pull the wire out.