DALI+Push+Phase Cut+0/1-10V LED Dimmer User Guide

Quick guide from the manual

This device is a multifunction 4-in-1 LED dimmer supporting DALI, AC Push, 0/1-10V, and Phase Cut dimming interfaces. Important: You must select the dimming interface using the DIP switch before wiring. Do not change the DIP switch setting while the device is powered. Only one dimming interface can be used at a time.

Safety & Warnings

• Do not install the device while power is applied.
• Do not select the dimming input interface while power is applied to the device.
• Do not expose the device to moisture.
• Ensure the rated current of the wire used is sufficient for the loads (0.5-2.5mm² wire specifications).

Operation

The device features a DIP switch to select the dimming interface. Before wiring, identify the control system you are using and set the DIP switch accordingly. Different dimming interfaces cannot be wired or used simultaneously. If using the DALI dimming input, the DALI address can be assigned by the DALI Master controller automatically; refer to the DALI Master manual for specific operations.

Wiring Diagrams

The device supports four wiring configurations based on the control method:

• DALI Bus: Connect the DALI signal to the DA terminals.
• AC Push: Connect the AC Push signal to the designated input.
• 0/1-10V: Connect the 0/1-10V control unit to the signal input terminals.
• Phase Cut Dim: Connect the Phase Cut Triac Dimmer to the input.

Note: The Push Dim and Phase Cut Dim input voltage range is 100-240VAC. The device provides 1 channel 12-36VDC output with two groups of terminals in parallel connection, each group loading a maximum of 10A.

Technical Specifications

• Input Voltage: 12-36VDC
• Output Current: 1x20A max
• Output Power: 1x(240-720)W
• Dimming Range: 0.1%-100%
• Ambient Temperature: -20°C to +50°C
• Waterproof Grade: IP20
• Dimensions: 170x53.4x28mm